Electronics Forum | Sun Aug 04 08:47:12 EDT 2019 | dfl
Hey bob, I had no luck. Even removing both glasses, cleaning that curved lenses with a cotton swab and isopropanol and blowing compressed air, the height still on 1. I will try on the next weekend again, to be sure, but my first guess is the QA un
Electronics Forum | Tue Jan 11 13:28:14 EST 2011 | jmw
0603 and up should be no problem on the machine. If you are doing under 25 mil pitch the machine needs an upward camera to repeatably place the parts. You will always lose the first 10 or so parts with cut tape but that should be about it. Repair par
Electronics Forum | Wed Jan 30 15:08:10 EST 2019 | dfl
MM, exchange the cards doesn't make any difference. The problem happens when the machine is moving from left to right. Right to left works all the time. bobpan, thanks, I completely missed this one. The default was 0 and now is set to 1. The build c
Electronics Forum | Fri Aug 02 08:12:55 EDT 2019 | dfl
Hey guys, I'm using my Quad IV-c for a while now and I already manage to run some batches, but I never used the "Quad Align" feature before, since almost all my boards are 1206 parts, that doesn´t need a ton of precision to align. Anyway,
Electronics Forum | Mon Jan 10 17:12:53 EST 2011 | gosswald
I have been researching older lower cost used Pick and Place machines and so far I am leaning towards the Quad IV C. There seems to be a fair amount of these units around and I have heard some pretty good things about them on some of the past posts.
Electronics Forum | Tue Apr 27 23:10:16 EDT 2010 | mbrunton
I am looking at buying a pick and place machine to assemble the circuit boards we make. Most of the boards are small (2 to 10 square inches), most are 2 sided, and have maybe 20-50 parts per side. I use mostly 0805/0603 chips, SOT-23, SOD-123, SOIC
Electronics Forum | Sun Feb 03 07:36:17 EST 2019 | dfl
Hey Steve, I wrote to Bob, but he doesn't reply yet. Digging around, I found these: HANDLING COMPONENT VARIETY The adjustable Pocket Index function enables handling a variety of component tape reels or special component packaging. The following ins
Electronics Forum | Sun Feb 03 07:39:27 EST 2019 | dfl
POCKET POSITION PROGRAMMING This procedure ensures the components are properly centered at the tape feeder pickup point (over spring stabilizer). NOTE: The feeder can be reset at any time by removing it from the feeder base and reinserting it. This
.png)
