Electronics Forum | Mon Apr 01 17:02:58 EDT 2013 | microaide
Yes! Thank you. That was not intuitively obvious, nor did the manual make that point clear at all. I can now create new SMD Types. Now if I just had the foggiest idea on how to set up and assign feeders, I might be able to generate my program. Right
Electronics Forum | Fri Aug 02 08:12:55 EDT 2019 | dfl
Hey guys, I'm using my Quad IV-c for a while now and I already manage to run some batches, but I never used the "Quad Align" feature before, since almost all my boards are 1206 parts, that doesn´t need a ton of precision to align. Anyway,
Electronics Forum | Sun Dec 04 02:20:20 EST 2011 | ngineer
I just got my hands on a Quad IVc, and am trying to find information on a Z-axis Error # 5 @ startup. I haven't really done anything since recieving the machine, I powered on, the Transport moves back and forth, the pc boots and I press enter to log
Electronics Forum | Tue May 07 14:47:31 EDT 2013 | ngineer
Z axis seems to move as it should, the flag that goes through the C shaped sensor is not broken. I have gotten it to stay on everytime i start it up now (I did NOT change anything, just unplugged it for awhile, then plugged it back in an flipped the
Electronics Forum | Thu Apr 17 16:55:32 EDT 2014 | bobpan
Hello, The only thing i can think of is the x&y ribbon cables. I know you said they are good but they could have an intermittent break. I would get a spare set and plug them in with the machine at a slow speed setting and see if it works as normal. A
Electronics Forum | Thu May 22 11:25:35 EDT 2003 | nad
Hi Jon, I recently had the opportunity to look over a used IIIc converted to a IVc. The documentation, software and spare parts supplied with the machine seem more than adequate, however, upon spending several hours cleaning, oiling, familiarizing,
Electronics Forum | Wed Jun 01 11:02:57 EDT 2016 | claudea2
I have 3 used Quad 4Cs and the nozzle changer on one machine never worked. I decided to troubleshoot it this week. I repaired the changer by changing a defective optical sensor but I still get error 17 when I try a run-step nozzle 1, 2 or 3. Error 17
Electronics Forum | Wed Nov 09 05:12:43 EST 2011 | bobpan
Motor error 4 is an error that is caused by the machine not reaching a position in a timely matter. Usually its in the x/y axis but also could be z. If you have cleared the mod codes (function 35 shift 7) the machine should home. Usually this problem
Electronics Forum | Mon Apr 08 19:06:52 EDT 2013 | microaide
So my board is called 850152, and is in a folder called BRD297XX.DIR. AutoProgram generates the pick and place program (for two heads) without error. When it does, two more "boards" appear. 850152A B1 in folder BRD2C7XX.DIR, and 850152A B2 in folder
Electronics Forum | Sat Jul 07 11:45:26 EDT 2012 | btipcb
I purchased and am setting up a used QSA30. It has been a little frustrating but I finally have an almost program. The isse is that I can not generate a placement program because it says that the ANC is not registered. I can look at it on the sy
