Electronics Forum | Mon Apr 13 14:48:38 EDT 2009 | bobpan
There is also a modify code that if set to 0 the quad-align will not turn on and you will have this error. It is one of the higher mod codes around 60-80......been so long i forget.... Good Luck Bob
Electronics Forum | Tue Nov 08 07:23:03 EST 2011 | leemeyer
Thanks Bobpan, A function 6 tells me that I have firmware ver IVC 3.05. I keep getting a motor error 4 "The Xand/or Y axis did not reach the commanded position within 500 msec." The battery was dead on this machine so the mod codes were lost. I en
Electronics Forum | Mon Apr 25 20:54:25 EDT 2011 | veeckm
Hello, First of all I am new to the forum and surface mount machinery in general. The machine in question has a problem picking parts correcly. The main problem seems to be that the camera and actual head location is out of calibration? If I do a ru
Electronics Forum | Fri Apr 12 19:20:25 EDT 2013 | microaide
Some progress, now stuck again. I can now generate a pick and place program for two heads that actually runs the head 1 program when loaded into the central controller of machine #1. But all attempts at getting machine #2 to run the head 2 program ha
Electronics Forum | Sat Jun 27 15:37:15 EDT 2020 | spoiltforchoice
rx8pilot has one of those - long thread here https://www.eevblog.com/forum/reviews/finally-have-a-pick-and-place-on-the-way-quad-ivc/ Clearly the platform itself is very well made although some of the weird debugging codes and errors posted on this
| 1 |
.gif)
winsouce.jpg)
