Electronics Forum | Tue Mar 12 07:46:26 EDT 2013 | ngineer
bobpan, It only happens with this program. CC ver 7.54, IVC V 3.05 If i leave CC out of it, and edit the sequence using the HHT, it sticks. but if i download from the assembler to CC, it's messed up. if i then fix it in CC, the minute i save
Electronics Forum | Sun Feb 03 07:39:27 EST 2019 | dfl
POCKET POSITION PROGRAMMING This procedure ensures the components are properly centered at the tape feeder pickup point (over spring stabilizer). NOTE: The feeder can be reset at any time by removing it from the feeder base and reinserting it. This
Electronics Forum | Tue Feb 07 05:35:56 EST 2012 | ngineer
If anyone else reads this because they blew up a feeder like mine, an appropriate capacitor for replacement is : Kemet T491D107K006AT Which you can find at mouser, or probably digi-key or newark. This is for the larger capacitors, i think they're
Electronics Forum | Tue Feb 07 05:36:22 EST 2012 | ngineer
If anyone else reads this because they blew up a feeder like mine, an appropriate capacitor for replacement is : Kemet T491D107K006AT Which you can find at mouser, or probably digi-key or newark. This is for the larger capacitors, i think they're
Electronics Forum | Tue Jan 17 11:10:51 EST 2012 | leemeyer
1. The flat black connectors that you are refering to are for the nozzle changers. 2. The nozzle changers can be mounted anywhere on the feeder base and their position must be taught using the handheld programmer. 3. If you have no power to the feede
Electronics Forum | Thu Jan 19 12:16:46 EST 2012 | leemeyer
I read back through your post. It seems that you do not have bases that belong with the 4C machine. I think that you have bases for Q series machines. That would explain why the connectors don't fit. You say that there are blocks on the feeder base.
Electronics Forum | Mon Jan 16 13:37:56 EST 2012 | leemeyer
When looking at the feeder base the right side wires should be white, black, black, red from top to bottom. The left side should be red, black, black, white from top to bottom. You have IQ feeders hence the extra pins. The IQ feeders are only require
Electronics Forum | Wed Jan 18 06:22:23 EST 2012 | ngineer
I rang out the bases, the connectors are common (i.e from top to bottom, 1-1, 2-2, 3-3,4-4). I also measured voltage on the connectors. Front and back don't have any voltage, and the lights don't come on when I press the buttons. Left and Right ar
Electronics Forum | Thu Jan 19 15:57:29 EST 2012 | ngineer
Yup, that sounds right. I did try one with red on top on one side and white on top on the other side. Oops, blew a capacitor out of the back of the base. If anyone else Has these, here's how it goes to make them work: Top pin on both sides = +12V
Electronics Forum | Mon Jan 16 00:47:47 EST 2012 | ngineer
I have two new quad feeder bases and feeders (my machine came with none to start, and I can't find any electrical information on them. I have 4 pins at the each end (total of 4 connectors. And are in a 4 pin connector which looks identical to a sta
