Electronics Forum | Tue May 07 09:33:04 EDT 2013 | ngineer
Yesterday, my Quad IVc was on, but not running. There was a power fluctuation. I immediately got a motor err #5. I checked all the doors were closed, tried to home / reset the machine, and then turned it off and back on. Neither breaker was trip
Electronics Forum | Tue May 07 09:32:39 EDT 2013 | ngineer
Yesterday, my Quad IVc was on, but not running. There was a power fluctuation. I immediately got a motor err #5. I checked all the doors were closed, tried to home / reset the machine, and then turned it off and back on. Neither breaker was trip
Electronics Forum | Wed Jul 06 08:02:54 EDT 2011 | jholif
bought the cable replacement kit and replaced all of the ribbon cables and still the deadly motor error 4. Everything in the system has been replaced except the X motor and the Y motor cable.
Electronics Forum | Thu Jun 30 14:25:42 EDT 2011 | bobpan
x and y ribbon cables would be my first guess...... good luck
Electronics Forum | Tue May 07 15:30:41 EDT 2013 | bobpan
your card is probably bad.....you can ohm out the motor and cable if you want... z motor windings 1.36 ohms z motor cable and windings 1.82 ohms good luck
Electronics Forum | Wed Jul 06 09:10:55 EDT 2011 | bobpan
i have seen bad motor cables cause the problem......you can ohm them out to the driver cards or if you have extras....replace them Bob
Electronics Forum | Sun Dec 04 15:42:21 EST 2011 | ngineer
Thanks for the reply bobpan. I had the motor power on. I did have a side panel that was not shut all the way. Once I shut that, the error went away and it made it through its startup sequence. No errors. Thanks for the help.
Electronics Forum | Wed Nov 06 13:27:55 EST 2013 | jeffl
Is there a schematic available online for this feeder or can anyone send me a schematic? I have an issue where the reverse does not work anymore. The switch (black button) is OK and the motor itself checks out OK. The problem is likely on the board i
Electronics Forum | Fri Feb 01 07:21:32 EST 2019 | dfl
One of my 8mm feeders is blinking the red led after the pick-up. With both buttons the motor works as expected (forward/backward), but after the nozzle pick-up the motor moves forward and then the red led blinks. pressing the buttons the green led l
Electronics Forum | Fri Mar 11 09:28:34 EST 2005 | Micheal
I need help on a Quad IVC. We are having intermitant problems. What happens is it runs and then all of a sudden the Z goes down into the feeder past the limit. I have changed the Z motor, cleared the memory, and also swapped motion controller boards
.gif)
winsouce.jpg)