Electronics Forum | Tue Oct 09 05:38:29 EDT 2018 | dfl
Hi, my Quad IV-c is showing a really dark image on the camera and its VERY difficult to see the components pads to make the adjusts. I already check the monitor brightness (at maximum and I can see the crosshair, so the monitor is good) and already
Electronics Forum | Tue Feb 28 12:23:36 EST 2012 | veeckm
It sounds to me like your using only the Global fiducial mode. If your running multiple images on one panel use image fiducials instead
Electronics Forum | Thu Aug 11 11:59:43 EDT 2005 | bobpan
no problem. Tell them to check old 'q-tips' and i believe it was called 'c-series odd placement' and there is a basic 'how to' on doing multi-rotated boards. Its not easy and could frustrate you but it will definatly work.
Electronics Forum | Tue Oct 09 06:14:48 EDT 2018 | bobpan
Move the camera over a feeder position and shine a flashlight to see if the image improves.....if it does....your light ring needs replaced or the led's need replaced in it. Sometimes just re-adjusting the angle of the led's in the ring can help. Go
Electronics Forum | Sun Jan 20 17:55:49 EST 2013 | ngineer
Mikej, I'm only running a single image, just want to correct for the slight variations in how the board seats in the transport. It's not more than a few mils off, but enough to cause an issue on fine pitch parts. I don't have any image fiducial
Electronics Forum | Wed Oct 08 13:30:04 EDT 2008 | bobpan
You need to check and see what you have 'y' set to in teach fiducials. Make sure you have only 1 with a 'y'(panel or multi-image fids)....then teach the appropriate one.
Electronics Forum | Mon Jan 21 08:36:23 EST 2013 | bobpan
The global or image fiducials is set under teach fiducials screen. You will get the option to turn on the one you want. You should choose one or the other depending on what you are building. You are correct for what tep hold,pass and tep vision does.
Electronics Forum | Wed Aug 10 20:49:27 EDT 2005 | bobpan
Quad/Tyco should have some old 'q-tips' on programming help for that type of board on a 'c-series machine'that i wrote a long time ago. I cant remember anymore exactly how to help you but they should have some paperwork on doing it. It also is a 'sli
Electronics Forum | Wed Aug 10 20:30:49 EDT 2005 | slthomas
I've got a new board (actually a new panel...a 4 up, with one row rotated, where it was a 2 up panel with no rotation before) that runs fine on the IVc but not on the IIIc. I've used the same reference points for the image rotation (fiducials) on bot
Electronics Forum | Thu Mar 02 08:37:15 EST 2006 | walbone
Thank you very much. I swapped the component length and width measurements in Autoprogram and it now places the SOT23's with image verification no problem. As for the 0402's I am still working on this. Pick and place is very new to me, well I start
