Electronics Forum | Mon Apr 25 20:54:25 EDT 2011 | veeckm
Hello, First of all I am new to the forum and surface mount machinery in general. The machine in question has a problem picking parts correcly. The main problem seems to be that the camera and actual head location is out of calibration? If I do a ru
Electronics Forum | Fri Aug 02 19:45:58 EDT 2019 | bobpan
haha....thanks Steve!!! Nozzle Height of 1 means that you have dust or something in the quadalign lens. You need to clean the lens with alcohol then a dry lint free cloth and if it stays the same....that means the lens has an issue or there is dirt
Electronics Forum | Mon May 09 16:32:05 EDT 2011 | veeckm
I got the camera nozzle offset corrected but after the machine runs for a while the offset will drift and its out the specs I set it to. Any help is appreciated.
Electronics Forum | Fri Feb 24 13:21:42 EST 2012 | bobpan
The correct sequence steps should be: 1. tep hold 2-? pick/place/nozzles tep vpass goto 1 This is out of the programming manual.
Electronics Forum | Fri Apr 08 21:39:17 EDT 2011 | jimlas53
Hi, We have a Quad IVc set up with all picks, placements, and sequence working. I have managed to get through several passes with some pain, mainly from SOT-23 parts, but it is getting better. On occasion, when picking from one of three feeders loc
Electronics Forum | Sat Jan 19 22:42:16 EST 2013 | ngineer
Ok, I managed to figure it out, and this is simply for anyyone having this issue. The issue was that the selected board or board folder did not reside in the selected board directory. the answer was to hold LSHIFT at startup to skip the autoexec of
Electronics Forum | Thu Aug 16 07:40:27 EDT 2012 | bobpan
Here are a couple of things to look at. 1. Watch the machine run....and if it misses a part....make sure it doesnt blow out the next part being presented. Sometimes the air pressure is too high and the vacuum verify will blow the part out of the poc
Electronics Forum | Tue Oct 10 12:32:08 EDT 2006 | RLM
Larry, I have had this problem in the past. It turns out that there wasn't enough "Z" on our nozzle pickup locations. When a nozzle change occured the nozzle would not be fully seated on the Z-rod. When the Z-rod is driven down to pick the first part
Electronics Forum | Thu Apr 17 11:59:59 EDT 2014 | briantmc
Hi all. A "newbie" on the forum, hopefully someone can help! I have a Quad IVc that has developed a problem on its Theta Axis. In performing the Homing routine it does not spin the nozzle through 360 deg as it should. It does a small turn ~45deg o
Electronics Forum | Tue Feb 07 05:41:20 EST 2012 | ngineer
I've got an issue, i can't seem to figure out. I think I need to apply a global offset to all my placements for some reason, and I would like to know why, before I do it. nozzles work, picks seem ok, but the placements are off by about 1/2 the widt
