Electronics Forum | Fri May 18 12:42:50 EDT 2018 | arachid
Hi, i search for drawing of calibration slug to calibrate a vu4/6 vision system on a quad 4c. on my manual it is name spindle runout calibration slug but not have part number. if you can give me this drawing i will very apreciate it. I need picture,
Electronics Forum | Thu May 20 09:47:25 EDT 2010 | pforister
Is this a single head Quad IVc or a dual headed line? if it is a dual line you can swap the align cards in the front bay between the two heads and see if the symptom follows. The card on the far right is a transport card, shouldn't need to swap tha
Electronics Forum | Mon Nov 29 18:23:19 EST 2010 | comprep
Has anyone had any success with placing BGAs with the Quad QSP-2? We have been having alignment issues with BGA placement but our placement of 0402 parts is dead on. We have worked through the calibration and it seems to be correct.
Electronics Forum | Fri Nov 29 08:36:07 EST 2002 | Jeff Park
They have there strong points and weak ones. I have worked with them for the last 5 years and have seen some flakey problems (Cables, feeders, encoders) that will cause you some down time but if you get a good price on a system it might be worth it.
Electronics Forum | Wed Nov 27 18:10:41 EST 2002 | andrewbrook
Quad4C's have their moments. If the price is right and you are aware of the machines limitations then you will be satisfied. The placement rate is slow, 1.2 seconds/chip. Don't buy any Quad if it has the CyberOptics Laser unit, the Quadalign unit is
Electronics Forum | Wed Jan 23 14:30:09 EST 2008 | operator
Additionally, I have seen the bad align error from incorrect pickup Z. Quad align can freak out sometimes if it sees something it doesn't like. If all else fails I just reboot and 99% of the time the problem goes away.
Electronics Forum | Wed Jan 23 14:26:52 EST 2008 | operator
I have seen the bad alignment error many times and never had to replace the head for it. It usually has something to do with the laser windows being dirty or cracked. Also it could be your profile settings. Make sure all of these things are perfect b
Electronics Forum | Wed Jan 23 11:28:47 EST 2008 | tbkonrad
Help! Since last Friday i have been having issues with a Quad qsv-1, it all started with a quad align error, i found there to be a small quantity of grease covering the lenses on both quad align sensors. I wiped the grease off and then everything s
Electronics Forum | Wed Jan 23 13:02:35 EST 2008 | tbkonrad
Thanks for the info. I called Mike Tieman earlier and he recommended I do the exact same things. He said that there should be very little resistance on the theta of the Z-rods, (not the case) so he recommended that the P4 head be replaced. Mike is
Electronics Forum | Wed Jan 23 12:35:24 EST 2008 | bobpan
Here is a few things to try.... 1. Spin the z-shaft with your fingers and make sure it is smooth and easy to turn. 2. Check your handling in your profile for the part that the software is locking up on.......You cannot go any slower than 40% or this
