Electronics Forum | Mon Apr 11 06:54:03 EDT 2011 | mosborne1
Wipe off your linear scales and clean your quadalign lense.
Electronics Forum | Tue Apr 19 14:58:05 EDT 2011 | rdoss
The ribbon cable would be my guess. I ran a IVc for about 3 years and we use to have to change out our cable at least once per year. I also wanted to add that you can contact Precision Placement Machines (PPM) for parts and service. We use to use
Electronics Forum | Fri Apr 08 21:39:17 EDT 2011 | jimlas53
Hi, We have a Quad IVc set up with all picks, placements, and sequence working. I have managed to get through several passes with some pain, mainly from SOT-23 parts, but it is getting better. On occasion, when picking from one of three feeders loc
Electronics Forum | Mon Apr 11 15:57:25 EDT 2011 | bobpan
If the feeders that you are having problems with have tall parts in them.....and these are the ones the machine is stopping on.....check to see that you are not scanning higher than what your function 30 nozzle height is. In other words...if your fun
Electronics Forum | Mon Apr 11 08:27:10 EDT 2011 | leemeyer
I have had similar problems before where the machine will intermittently stop with a limit error. Reset the machine and away it goes. Replacing the ribbon cable that runs from the head (37 pin D-sub)has solved this problem. This cable gets flexed a l
Electronics Forum | Thu Jan 19 10:53:43 EST 2006 | bobpan
Walter, Read what i posted above about switching the dip switch 8 on dip 1. That will probably solve your problem but once again....make sure you write down all your machine settings because everything will be reset.
Electronics Forum | Mon Jun 13 19:07:57 EDT 2005 | bobpan
Mike, Right down all the settings you have for your machine (this may take a while). Also back up the programs you want to save. Now....if i can remember correctly.....when looking into the black computer box from the back of the machine...in your bo
Electronics Forum | Tue May 31 07:04:20 EDT 2005 | bobpan
Mike, There was a dipswitch that can be changed that will clear the machine settings and reset everything back to defaults. You will also lose your programs so backing up everything is a must. If you need and/or want to do this let me know and i will
Electronics Forum | Wed Feb 23 15:19:49 EST 2005 | Dilbert
I don't work on quads but I can give you some things to look for... Each of the moving axis work off a motor that is controlled by a "drive". Some of these drives have a fault or error output that is connected to the motion controller. One of your
Electronics Forum | Thu Sep 08 13:07:18 EDT 2016 | claudea2
Hello Bob, we changed the nozzle z parameter until we got limit errors and backed up 1 mil. There was a slight reduction in the limit errors on the pickup of the component but it is still a problem. With the mod code we adjust the soft z height to ab
.gif)
winsouce.jpg)