Electronics Forum | Wed Nov 27 09:51:08 EST 2002 | Claude_Couture
I have worked with 4c's for two years. The feeders are "tinker toys" with a mechanism that slips, so the pick-up has to be adjusted several times as the reel is used, especially with 13" reels. The worm gear was plastic on the steel shaft of the moto
Electronics Forum | Wed Jun 01 14:58:45 EDT 2016 | claudea2
I answered my own question. The nozzle changer was in the left front, moving it to the left back fixes the problem.
Electronics Forum | Wed Jun 01 11:02:57 EDT 2016 | claudea2
I have 3 used Quad 4Cs and the nozzle changer on one machine never worked. I decided to troubleshoot it this week. I repaired the changer by changing a defective optical sensor but I still get error 17 when I try a run-step nozzle 1, 2 or 3. Error 17
Electronics Forum | Mon Aug 04 08:05:17 EDT 2008 | leemeyer
I have dealt with a shop called Count on Tools. They can be found on the net. They make Quad nozzles for a fraction of the cost that Quad/Tyco charges.
Electronics Forum | Tue Oct 10 12:34:43 EDT 2006 | bobpan
Larry, Do a runstep nozzle then open the door and look and see if the nozzle is all the way on. Push up on it and see if it moves up
Electronics Forum | Tue Oct 10 12:32:08 EDT 2006 | RLM
Larry, I have had this problem in the past. It turns out that there wasn't enough "Z" on our nozzle pickup locations. When a nozzle change occured the nozzle would not be fully seated on the Z-rod. When the Z-rod is driven down to pick the first part
Electronics Forum | Sat Feb 02 14:19:16 EST 2013 | bangerla
Could someone provide the size or source for the o-rings on the z rod of a Quad IVC, which hold the nozzle?
Electronics Forum | Wed Oct 12 12:54:27 EDT 2016 | toddm
I need to do a camera to nozzle calibration on a Quad IVc. I was told to use silly putty. I now need to know step by step what to do.
Electronics Forum | Mon Feb 04 11:01:44 EST 2013 | bobpan
The way its supposed to work...is....when you do a function 30 the z axis should step down until the nozzle tip is seen in the quad align or laser align. The readout should have a nozzle height but if its the earlier firmware for the machine it might
Electronics Forum | Fri May 14 16:07:44 EDT 2004 | gregp
Here's a couple for starters...don't know quality or pricing. http://www.cotinc.com/Pages/Quad.htm http://www.goppm.com There are others who make replacement nozzles as well as other spare parts.
