Electronics Forum | Mon Feb 08 15:54:22 EST 2021 | bobpan
I think in the machine configuration there is an option to use the vacuum or not. Its been a long time but i think you just just skip past the vac message if it pops up. Pust both left buttons at the same (under the display) time to get into the mach
Electronics Forum | Tue Feb 09 10:01:08 EST 2021 | bobpan
1. The resistor is normally hot. 2. If the machine is crashing towards the front then the system settings need reset. Do this by pressing and releasing the e stop then pressing both front left buttons on the mylar below the lcd screen. Go into the ma
Electronics Forum | Thu Mar 04 14:55:48 EST 2021 | mendez
Thanks a lot! I sent the boards to REPRINT in UK, and I'm waiting to get them deliver to do the final testing. Are these printers very reliable? I heard that if you have the stencil cleaner (my has) to avoid using it since it was a bad design and bu
Electronics Forum | Thu Mar 04 15:11:45 EST 2021 | mendez
Thats good to hear. I have (1) extra boards for the LCD and the Motion drivers in case something gets damaged later because as you mentioned; parts are very difficult to find (or super expensive) I did soldered the IC chip on the LCD unit and get RE
Electronics Forum | Wed Apr 08 14:41:35 EDT 2015 | kevinb
I have a Quad QSV-1. When I was teaching the fiducials, an error came up on the screen. ABNORMAL PROGRAM TERMINATION came up. It might have read something different but this was close. It then closed out of the quad program and went to the window
Electronics Forum | Fri Feb 29 09:15:23 EST 2008 | jdengler
I do not know the QSV-1, but it sounds like there is a sensor that would detect when the clamp is open. Try to find this sensor and see if it is working.
Electronics Forum | Mon Apr 13 16:02:17 EDT 2009 | abdelga
Anyone with any thoughts (pro or con) for the following options for Quad, QSV-1 pick and place?: detachable feeder bases IQ system
Electronics Forum | Wed Nov 23 09:22:16 EST 2016 | hloranzo
on the quad Qsv1 plus the z1 board has a amber light not green ,,, swap the z2 board and still amber light help please
Electronics Forum | Wed Nov 23 10:02:57 EST 2016 | hloranzo
on the quad Qsv1 plus the z1 board has a amber light not green ,,, swap the z2 board and still amber light help please gantry Z1 movement failure
Electronics Forum | Sat Feb 06 15:47:01 EST 2021 | mendez
Hello, I'm new to this forum. I recently purchased a 100MV Screen printer and unfortunately; it arrived damaged. I was able to turn the unit on and I was able to get the unit do the initiation process (ex. datums). When I tried to do a sample PRIN