Electronics Forum | Mon Feb 08 14:29:20 EST 2021 | mendez
Great. I just send them an email; I appreciate your support. Quick question: I found it odd that the printer seems to be working fine when I turn it on for the first time. But as soon as I push the two "PRINT" buttons, a window of VAC came up and th
Electronics Forum | Thu Mar 04 15:01:32 EST 2021 | proceng1
We used to have 5 of these in service and they worked great. Only 1 had the stencil wiper, and we did not utilize it. We've since installed all inline printers, but we do keep 1 MV100 on the floor as a back up. The firmware can get squirrely and the
Electronics Forum | Mon Feb 08 23:16:07 EST 2021 | mendez
Hi, so I was able to turn the machine on for a few seconds. It looks like the IC on the LCD doesn't have goo contact because it's very hard to keep the machine operational. I was able to see the table lifting for the first time; it was so cool! but t
Electronics Forum | Mon Oct 05 21:25:19 EDT 2015 | ngineer
I have a quad qsv-1 machine that I'm trying to get up and running. I cannot get past the Q-Soft part where it wants to create an RT boot disk. I put my 1.44M floppy in drive A:, hit enter, it says it's creating the boot disk and then errors out say
Electronics Forum | Fri Oct 12 10:21:03 EDT 2012 | chox
I am looking for someone to contract to come to our facility to provide training on Philips Topaz and/or Quad QSV-1. We are looking for programming, operation and maintenance training. I would prefer someone local.
Electronics Forum | Tue Oct 06 05:55:56 EDT 2015 | bobpan
There are known problems trying to create the boot disk if its the older quad software. Contact me through: www.precision-repairs.com I might be able to help you. Bob
Electronics Forum | Mon Dec 12 12:25:11 EST 2005 | John
I'm having problems feeding these to the pick and place. As the tape peels off the pocket the part sticks to the tape rather than remaining in the pocket. Machine is QUAD QSV. We've tried all generations of feeders we have available. Any advice is
Electronics Forum | Fri Feb 03 13:01:52 EST 2006 | MazinK
Hdello BOB, I sent you a message yesterday regarding the machine I have here, Can you please help me, since I knew from people here that you are a good help. Thanks
Electronics Forum | Fri Feb 29 09:13:46 EST 2008 | bobpan
I have seen this on our assemblers look in the machine and check to be sure there is no obstruction IN the down flag sensor located on the bottom of the front transport assembly.
Electronics Forum | Tue Mar 18 22:48:24 EDT 2008 | lectronix
We were told to turn on the air supply prior to turning on the power to the machine. We see this error when we forget to turn the air supply on first, you can just aknowledge the error and it will work.