Electronics Forum | Wed Nov 17 12:12:30 EST 1999 | Wendy Casker
Well, I was using a quad QSV-1 for boards this size. Not the fastest, but it was able to handle the large boards in a pass through machine. Keep in mind the board thickness, as well. Anything over 0.2" will not fit in the clamps of the conveyors.
Electronics Forum | Sun Feb 09 19:16:22 EST 2014 | navworx
Was running production when the head just came to a stop, motor went off, error window said to home. Upon attempting to home, got message: G1T2 homing error; index mark not found. I've tried rebooting the machine, but this error still appears. Any
Electronics Forum | Wed Apr 08 15:09:17 EDT 2015 | bobpan
Your UPS did not shut down properly....reset it by going in through the bottom right side cover (exit end of the machine) and press the reset button on the ups. The machine should then work properly. Next is why the fiducial froze up. If you mistyped
Electronics Forum | Thu Apr 09 08:22:19 EDT 2015 | bobpan
Sounds like the battery or batteries inside are dead. You can just plug the input and the output on the back of the unit into each other. The ups is not needed on the machine and was only used so that you can shut down the computer properly incase th
Electronics Forum | Wed Jun 27 08:47:02 EDT 2018 | Dex
What would you recommend? I am inquiring to see if this machine would include any of those 0402 or 0201 feeders. We have products that contain 0402s currently and it is a giant struggle with this CP43. We would like something that can place 0402 and
Electronics Forum | Fri Jun 29 09:04:41 EDT 2018 | kdexter0928
Wow, its that much slower? If it were my decision we wouldn't be going from one old platform to another. As you said budget is the problem in this case. I am not sure that they want to spend the money on this let alone something newer. They would lik
Electronics Forum | Fri Feb 29 08:27:34 EST 2008 | tbkonrad
This morning I turned on our Qsv-1 and ai resiveved the following error. "Clamp did not open: House Air pressure may be lower then 70 psi" after checking the Air Pressure it reads at 80 psi on the Main air pressure gauge as well as the 80 psi on the
Electronics Forum | Tue May 08 15:00:26 EDT 2012 | jorge_quijano
Hello guys, I have a error message in a QSV-1 machine, when it tuns on "File archive error occurred while reading header of table top:permanent table top", I have no experience with this machine, so no good so far, already escalated to service and wa
Electronics Forum | Fri May 09 05:09:41 EDT 2014 | col_d
We're having an intermittent fault with a QSV-1 where it will on occasions oscillate violently during a run and this usually results in 1 or both Z-rods being destroyed, along with the nozzle currently fitted. This has been on and off for the last 2
Electronics Forum | Tue Jun 26 15:27:14 EDT 2018 | Dex
Why would we change? our fuji equipment was previously owned by Motorola and have many hours on them. we struggle to place 0402 components and the vision system on the CP seems to be one foot in the grave. The machines are tired and have been ran har
