Electronics Forum | Tue Nov 30 06:33:44 EST 2010 | jmw
If you are using the upward camera then you probably have to put in a placement offset for each head. This only effects upward camera placements...not quadalign. This is located in: 1. machine-calibration-camera lens 2. Choose upward camera2 under "
Electronics Forum | Wed Nov 27 18:10:41 EST 2002 | andrewbrook
Quad4C's have their moments. If the price is right and you are aware of the machines limitations then you will be satisfied. The placement rate is slow, 1.2 seconds/chip. Don't buy any Quad if it has the CyberOptics Laser unit, the Quadalign unit is
Electronics Forum | Mon May 16 22:06:22 EDT 2011 | danaherr
Downward looking camera not working. swapped cables on board and upward looking camera works when plugged into downward camera's connection on video card. Thinking maybe a cable issue??? manually moved gantry all over trying to see if intermitent ope
Electronics Forum | Wed Jan 12 09:47:14 EST 2011 | gantry
Definitely agree with JMW, most machines you find will already have the upward looking camera unless it was the first (or second) head in a multi-head system. I would not look at a C-series without the upward looking camera
Electronics Forum | Mon Oct 09 13:36:30 EDT 2006 | ppminc
Phil, The QSA-30 was built by Sam Sung, Sold by Quad. Single Head 2 Nozzles around 11K CPH Quad does not support the machine but I believe you can get parts direct from Sam Sung. I am not sure if they have a registration fee. The QSA used Quad made
Electronics Forum | Tue Nov 01 13:57:18 EST 2005 | bobpan
2c belt driven.....'a little' less accurate (costs less) 4c ball screw......'a little' more accurate (costs more) vu4-vu6 upward camera for fine pitch.....cant remember but the differenc is the field of view for camera. part centering is quad-align
Electronics Forum | Mon Dec 12 08:05:11 EST 2005 | bobpan
Quad Align.....Cyber-optics....no difference...they both work well. Never tried a micro-bga but i know the upward camera does standard bga parts.
Electronics Forum | Tue Jan 11 16:38:18 EST 2011 | gosswald
JMW, Thank you for your reply. Can you add the upward camera to this machine that does not have it after purchase? If so what is involved? I do have typically two items per board that would be below 25 mil pitch.
Electronics Forum | Mon Dec 25 17:28:43 EST 2023 | bobpan
I dont know if vision on spin fail was ever for small parts....its more for bigger fine pitch that fail in the quadalign and then given another chance to pass over the upward camera.
Electronics Forum | Mon Nov 16 05:55:29 EST 2015 | bobpan
Hello, Average correction should be used. If the nut on the z-rod is what you are seeing through the parts leads...you can use a smaller o-ring and slide it up to where the nut is to block it out. You may have to try a few sizes and/or even double ov
