Electronics Forum | Wed Nov 27 18:10:41 EST 2002 | andrewbrook
Quad4C's have their moments. If the price is right and you are aware of the machines limitations then you will be satisfied. The placement rate is slow, 1.2 seconds/chip. Don't buy any Quad if it has the CyberOptics Laser unit, the Quadalign unit is
Electronics Forum | Tue Aug 10 15:21:46 EDT 2010 | tanderson
I'm having problems with Quad QSP-2 pick n place machines recognizing fiducials. We are cleaning the fiducials, but that's tedious and time consuming ( I don't know anyone who routinely cleans them). We have solder mask clearance around the fiducials
Electronics Forum | Tue Jun 12 15:12:47 EDT 2012 | tanderson
We clean (using a pencil eraser) the fiducials on all our PCBs before processing them through a QUAD QSP-2. We're discussing pcb's with our fabricator to see if they have recommendations. Some of our Engineers believe it is the QUAD that's the proble
Electronics Forum | Fri May 09 00:18:42 EDT 2014 | tuanly
To all experts in house, If by chance any one can tell me where to buy or down load the Owner Manual /User guide book for Quad -QSP-II SMT machine. Or step by step instruction how to teaching board Fiducial on this Quad QSP-II. Thank you all in adva
Electronics Forum | Sun May 11 17:32:23 EDT 2014 | bobpan
I have a procedure on teaching fiducials on the machine with and without cad. The manual does not tell you how to do this. Give me an e-mail address and i will send it to you. Thanks
Electronics Forum | Thu Jun 06 05:29:09 EDT 2019 | heinar
Hallo...Quad have problem with z, going to wrong. Parst to high and can not measuring. No errors. Have some body this problem and solutions? Thank you.
Electronics Forum | Thu Nov 12 04:40:03 EST 1998 | Galen
| Scott - Good to see things are going well for you. With regard to your comments, Quad has introduced a complete line of Semi-conductor/APT machines (Q Series) that support both SMT and Semi-conductor applications. The machines were introduced in
Electronics Forum | Thu May 02 09:08:13 EDT 2002 | darryl
I have a Quad QSP-2 for 5 years and I have had no problems with it. We run it 16 hours per day 6 days a week. Software is good. Service is excellent Quadcare is expensive. The only drawback that I see is tapefeeder repeatability. Seems that the p
Electronics Forum | Wed Jun 19 10:11:59 EDT 2019 | jamesn
Hi to everyone I hope someone can help me with a problem I have on a Quad QSP-2. when calibrating ( Or trying to use ) Feeder Bases 2 and 4 on gantry 2 Im getting small amounts of accumulative drift in the X axis. I have changed the servo amplifier
Electronics Forum | Mon Apr 24 07:37:57 EDT 2006 | craig_83
We have the IQ system. The problem that I was having is that when I load one board to the other, I want to avoid the table top changeovers. So I figure if I can make certain tabletops to run certain boards the changeovers would be much less. I though
.gif)
winsouce.jpg)