Electronics Forum | Tue Nov 30 06:33:44 EST 2010 | jmw
If you are using the upward camera then you probably have to put in a placement offset for each head. This only effects upward camera placements...not quadalign. This is located in: 1. machine-calibration-camera lens 2. Choose upward camera2 under "
Electronics Forum | Mon Sep 15 23:59:09 EDT 2014 | marcelorotofrance
Hi evreybody I wish to know if somebody can describe how is made a "Calibration Slug" for centering the upward camera of a QUAD IVC machine. The instruction manual mentions a slug that is attached with vacuum to the "Vision Nozzle" and there is some
Electronics Forum | Sat Aug 18 00:49:56 EDT 2012 | audere
When I see this on my QSP2 it is always caused by the nozzle not seating ideally but I tend to set my tolerances really tight. To test mount a nozzle and look at Z height. Now pick up the part (which in my case will suck the nozzle upward due to the
Electronics Forum | Thu May 22 17:17:37 EDT 2003 | ssnow
I have to agree with you on the documentation side of the manuals ,they were written before they ever hired a tech writer, when they finally did they wrote manuals for the newer stuff and let the older machines alone. The basic's are pretty straight
1 |
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723