Electronics Forum | Wed Nov 27 18:10:41 EST 2002 | andrewbrook
Quad4C's have their moments. If the price is right and you are aware of the machines limitations then you will be satisfied. The placement rate is slow, 1.2 seconds/chip. Don't buy any Quad if it has the CyberOptics Laser unit, the Quadalign unit is
Electronics Forum | Wed Jan 23 15:13:54 EST 2008 | tbkonrad
It's not the z pickup or profile bot thanks for the help, I think Mike is right. I have used these profiles hundreds if not thousands of times in the past and never had an issue. Also it was different components and different profiles almost every ti
Electronics Forum | Fri Nov 29 08:36:07 EST 2002 | Jeff Park
They have there strong points and weak ones. I have worked with them for the last 5 years and have seen some flakey problems (Cables, feeders, encoders) that will cause you some down time but if you get a good price on a system it might be worth it.
Electronics Forum | Thu Nov 21 11:35:47 EST 2002 | hannahsd
We had several 4c's before we put them out to pasture. From my experience they are easy to make program adjustments, but like the previous person responded the auto programmer did not work for us. We had laser coplanarity check as an addition to th
Electronics Forum | Wed Feb 23 15:28:50 EST 2005 | c.b
Thankyou also dilbert, have reset the machine, and given it a maintenence check they are pretty basis thing's and these machines usually only stop when it is user error! will try the slow running mentioneed from bobpan and will also try your suggesti
Electronics Forum | Thu Jan 19 10:58:59 EST 2006 | bobpan
Doesn't Karl Mohor with KTI still service the equipment down there???
Electronics Forum | Thu Jan 19 10:53:43 EST 2006 | bobpan
Walter, Read what i posted above about switching the dip switch 8 on dip 1. That will probably solve your problem but once again....make sure you write down all your machine settings because everything will be reset.
Electronics Forum | Wed Feb 23 15:19:49 EST 2005 | Dilbert
I don't work on quads but I can give you some things to look for... Each of the moving axis work off a motor that is controlled by a "drive". Some of these drives have a fault or error output that is connected to the motion controller. One of your
Electronics Forum | Mon Jun 13 19:07:57 EDT 2005 | bobpan
Mike, Right down all the settings you have for your machine (this may take a while). Also back up the programs you want to save. Now....if i can remember correctly.....when looking into the black computer box from the back of the machine...in your bo
Electronics Forum | Tue Feb 06 10:43:18 EST 2007 | James
Especially on capacitors, the tape is so thick that the motor starts to slow down and does not advance the parts fast enough or not at all. This happens on regular 8mm.
.png)