Electronics Forum | Fri Nov 29 08:36:07 EST 2002 | Jeff Park
They have there strong points and weak ones. I have worked with them for the last 5 years and have seen some flakey problems (Cables, feeders, encoders) that will cause you some down time but if you get a good price on a system it might be worth it.
Electronics Forum | Wed Nov 27 18:10:41 EST 2002 | andrewbrook
Quad4C's have their moments. If the price is right and you are aware of the machines limitations then you will be satisfied. The placement rate is slow, 1.2 seconds/chip. Don't buy any Quad if it has the CyberOptics Laser unit, the Quadalign unit is
Electronics Forum | Wed Nov 27 09:51:08 EST 2002 | Claude_Couture
I have worked with 4c's for two years. The feeders are "tinker toys" with a mechanism that slips, so the pick-up has to be adjusted several times as the reel is used, especially with 13" reels. The worm gear was plastic on the steel shaft of the moto
Electronics Forum | Thu Jan 19 07:50:19 EST 2006 | Walter
HI bobplan.... ! I'm brazilian an i have a error message too ! But the message is "System Error... Please Check the system" And the machine freeze ! Please .. help me !
Electronics Forum | Fri May 18 12:42:50 EDT 2018 | arachid
Hi, i search for drawing of calibration slug to calibrate a vu4/6 vision system on a quad 4c. on my manual it is name spindle runout calibration slug but not have part number. if you can give me this drawing i will very apreciate it. I need picture,
Electronics Forum | Mon Jun 19 09:53:27 EDT 2017 | tnisbet
Hi, Yes you can add a paste dispenser to the Quad 4C. The system will dispense DOTS and DOT patterns, no lines. We sell kits to add the dispenser. It takes about 4hours to install the kit. We also sell Camalot dispensers, benchtop & floor models. w
Electronics Forum | Mon Jun 19 08:49:40 EDT 2017 | westshoredesign
Just buy a separate machine to apply paste. You'll be able to run faster, (by doing more at the same time) and you can probably find an air-over-syringe system for less than $2000USD. At the end of the day, that's probably less than you'll spend in t
Electronics Forum | Wed Aug 01 01:35:22 EDT 2001 | DL
Jay, I agree with your assement and Chips on the Quads. I once worked at a shop that had Quads and DynaPerts(at the time) The perts were slower(TIME) and required(EFFORT/PEOPLE) more MAINTENANCE(more effort more people and more requirements!!!). I'v
Electronics Forum | Wed Aug 01 09:36:17 EDT 2001 | Pete Barton
Jay, > > I agree with your assement and Chips on > the Quads. I once worked at a shop that had Quads > and DynaPerts(at the time) The perts were > slower(TIME) and required(EFFORT/PEOPLE) more > MAINTENANCE(more effort more people and more > re
Electronics Forum | Sat Sep 30 23:57:11 EDT 2000 | DL
I have to agree with Geo. I've a number of years exp. with Quad Machines and currently waiting for the Installation of the APS-1H so I can be trained. However, the quad techs take no prisoners when it comes to chasing down bugs. The Meridian is Quads
.gif)
winsouce.jpg)