Electronics Forum | Mon Feb 06 13:16:49 EST 2006 | mazink
Hello BOb, Sorry, I wasn't getting your responed because i wasn't log in completlt. I sent an email yesterday which is as follow.. I have a quad machine (QSV 1 PLUS) here and I been having problem with it since 2 month. massege keep coming says 1) B
Electronics Forum | Fri Feb 03 14:32:59 EST 2006 | mazink
Hello BOb, Sorry, I wasn't getting your responed because i wasn't log in completlt. I sent an email yesterday which is as follow.. I have a quad machine (QSV 1 PLUS) here and I been having problem with it since 2 month. massege keep coming says 1) B
Electronics Forum | Mon Feb 06 19:56:07 EST 2006 | bobpan
Ok....that is very vague...but here is the approach i would take. 1. rename permanen.tbl file and reboot 2. rename calibrat.arc file and reboot * both files are located in c:\2kla\gui\guiqsv1* If it fixes the problem....it was a software issue. 3. If
Electronics Forum | Wed Feb 23 15:19:49 EST 2005 | Dilbert
I don't work on quads but I can give you some things to look for... Each of the moving axis work off a motor that is controlled by a "drive". Some of these drives have a fault or error output that is connected to the motion controller. One of your
Electronics Forum | Mon May 16 17:58:54 EDT 2005 | ??
Are you sure you dont mean quad 100. The software for a quad 1000 (which was a samsung machine) was not available on disks or to install......I dont recall ever seeing it on a disk. If its a quad 100, you would need version cc5.6d central controller
Electronics Forum | Fri Jul 26 09:37:45 EDT 2019 | babe7362000
I got it BOB, just the TEP card needed seated more. Thanks
Electronics Forum | Fri Jul 26 15:12:28 EDT 2019 | bobpan
woohoo....good job.
Electronics Forum | Thu Jul 25 14:18:34 EDT 2019 | babe7362000
It's been awhile but I was wondering if anyone knows how to read the LED's on the Tep board to what they mean. Top 4 Red 1. blinking red 2. lit red 3. off 4. lit red 5. lit red 1. blinking green 2. not lit 3. lit green 4. off 5. off On the Gui
Electronics Forum | Thu Jul 25 16:20:59 EDT 2019 | bobpan
Top red led is on or off depending on version of tep board. The green leds light when the transport sensor that it communitcates with is seeing a board over it. Tep controller init failure can be one of the following. 1. Check reseat tep card and
Electronics Forum | Sun Jan 20 17:47:41 EST 2013 | ngineer
Bobpan, It's been a while, and I haven't really had a need for this (simple boards, with larger components), but now I'm back to a board that needs this. I only have options for HOLD, PASS or VISION under transport in the Sequence Programming.
