Electronics Forum | Wed Jan 23 13:02:35 EST 2008 | tbkonrad
Thanks for the info. I called Mike Tieman earlier and he recommended I do the exact same things. He said that there should be very little resistance on the theta of the Z-rods, (not the case) so he recommended that the P4 head be replaced. Mike is
Electronics Forum | Wed Jan 23 15:13:54 EST 2008 | tbkonrad
It's not the z pickup or profile bot thanks for the help, I think Mike is right. I have used these profiles hundreds if not thousands of times in the past and never had an issue. Also it was different components and different profiles almost every ti
Electronics Forum | Wed Jan 23 14:30:09 EST 2008 | operator
Additionally, I have seen the bad align error from incorrect pickup Z. Quad align can freak out sometimes if it sees something it doesn't like. If all else fails I just reboot and 99% of the time the problem goes away.
Electronics Forum | Wed Jan 23 12:35:24 EST 2008 | bobpan
Here is a few things to try.... 1. Spin the z-shaft with your fingers and make sure it is smooth and easy to turn. 2. Check your handling in your profile for the part that the software is locking up on.......You cannot go any slower than 40% or this
Electronics Forum | Sat Jan 13 19:34:16 EST 2007 | geb
(Its a flex head) I have made a trial program to determine at what point it stops. This is how it goes: I load the program, push the start button it will zero and pick components with head 1. As soon as it finishes placing head 1 parts it halts wher
Electronics Forum | Thu Sep 21 14:15:09 EDT 2006 | lheiss
A list would be great. Thanks, Larry lheiss@speastech.com
Electronics Forum | Mon Dec 14 08:14:07 EST 2015 | ahanna
We have a Quad 4000c refurbished from PPM. I have worked with quads for many years and this one seems to bend Z-Rods more than usual. In the past few months we have gone through nearly 10 Z-Rods. This is getting expensive. This is happening during pr
Electronics Forum | Wed Sep 20 18:12:07 EDT 2006 | lheiss
I forgot to ask if anyone knows what numbers I should get for function 30, nozzle height and center of rotation? I'm getting 365 for height and 12314 for center of rotation. I know it isn't 12.314 inches out!
Electronics Forum | Thu Sep 21 08:06:15 EDT 2006 | bobpan
I think 365 is ok. You should check and make sure the z-rod's spring is ok. Just make sure it is not sticking. Dont waste your money on the pm. If you want a complete list of things to do.....leave an e-mail address and i can e-mail you a list.
Electronics Forum | Sat Feb 02 14:19:16 EST 2013 | bangerla
Could someone provide the size or source for the o-rings on the z rod of a Quad IVC, which hold the nozzle?
winsouce.jpg)
