Electronics Forum | Thu Jul 31 07:28:04 EDT 2008 | leemeyer
This sounds like a Quadalign problem. Upon startup the Quadalign system checks runout of the Z-rod and tries to find the tip of the nozzle. It will keep lowering the Z-rod and looking for the tip until it hits it's limit. Check and see if the Quadali
Electronics Forum | Sat Aug 02 15:00:12 EDT 2008 | miroyu
I built aluminum cage add ground wire to it but my problem is not gone!Also , video is not in focus.How can I make it right.Does this shows that quadalign board is foulty? Any comments PLS? Thank you Miro
Electronics Forum | Tue May 31 14:23:16 EDT 2011 | gosswald
I bought an “as is’ Quad IIC package a while back. The machine definitely has issues with the Quadalign Board. The ICs were literally falling off of the board. I am guessing when it was manufactured they did not get the PC board quite hot enough or s
Electronics Forum | Mon Apr 13 14:36:18 EDT 2009 | leemeyer
I have seen this problem before. There is a cable that runs from the Quadalign board to the backside of the backplane. It is not secured in any way so it may have come loose in shipping. Open the right side panel on the machine. The Quadalign board
Electronics Forum | Thu Jul 31 10:45:13 EDT 2008 | miroyu
thank you very much. In my case quadalign board is at rear right corner but it does not have cage just is fitted on vertical aluminum metal sheet plate.I will add ground wire to the board and aluminum plate from machine ground. I will post what is o
Electronics Forum | Mon Sep 24 20:34:46 EDT 2012 | saduquette
Hi All, I have a Quad 4C that the quadalign processor started acting up on. Where the Hand Held Progrmmer would hang at "Laser Align Init" when you first turn the machine on. A couple of times I was able to get it running by pressing the re
Electronics Forum | Thu Dec 29 05:56:37 EST 2005 | bobpan
Dont quote me on this because its been a while but i believe thats a grounding issue on the quad-align card itself. The card is located in the rear right bottom of the machine. Try adding a ground wire to the cage that the card is mounted inside. Als
Electronics Forum | Wed Nov 27 18:10:41 EST 2002 | andrewbrook
Quad4C's have their moments. If the price is right and you are aware of the machines limitations then you will be satisfied. The placement rate is slow, 1.2 seconds/chip. Don't buy any Quad if it has the CyberOptics Laser unit, the Quadalign unit is
| 1 |
.gif)
.gif)
