Electronics Forum | Mon May 16 16:40:50 EDT 2005 | russ
Fred, give us a quickie at what you will be soldering Single sided thu hole, double sided SMT, both, lead pitches and protrusions, Flux type, and such. Buying a used wave can be tricky and the more info up front the better we will be able to tell yo
Electronics Forum | Tue May 17 10:11:54 EDT 2005 | russ
I would use a foam fluxer since spraying rosin will make the stickiest nastiest mess you can imagine. 18 layer board huh? You will want convection preheat, both top and bottom preheaters, preheat tunnel of at least 4-5', a chip wave, laminar flow w
Electronics Forum | Tue May 17 09:58:42 EDT 2005 | Fred N
Thx to everyone who replied. we will be running single sided thru hole and double sided smt, 186 rosin flux cause they tell me it can take the heat needed for 18 layer pwbs. some long leads. also they are ordering in pallets to deal with the irregu
Electronics Forum | Tue Nov 03 18:56:22 EST 2020 | goldendragon
All, I'd like to know what a good used wave pb-free solder machine out there? Appreciates!
Electronics Forum | Mon May 16 15:33:52 EDT 2005 | jasont
Hi Fred, Will you consider used waver solders? I wills end you a list of pre-owned, good working waves that we have in stock. Regards, Jason
Electronics Forum | Mon May 16 17:05:17 EDT 2005 | pde
Also concider if you will be going lead free in the future as conversion can be a added expense. You may think about learning and going lead free from the begnining as the indestry is rapidly moving in this direction.
Electronics Forum | Mon May 16 15:22:54 EDT 2005 | Fred N
the company i work for is going into circuit boards and want to find a used wave solder machine theyre budget is 10 to 20 k i have never run one of these machines and dont no what to look for anybody out there have recommendations of what i
Electronics Forum | Mon May 16 18:03:30 EDT 2005 | davef
Key Issue: Will this machine solder your boards? You never know until you solder one. Any other avenues of analysis involve substantial risk. Flux Selection * High or low solids * VOC or VOC-free Solder Alloy * If using lead-free, avoid stainles
Electronics Forum | Fri Jan 28 12:30:57 EST 2005 | glenda
We are looking for a used or new wave machine must be able to do lead free solder. Does anyone have contact information in the Chicago, il area for used wave soldering machines? Thanks for any help we can get.
Electronics Forum | Wed Nov 17 11:20:23 EST 1999 | Dave F
Hey Gyver: If you don�t mind (which you don�t have any choice about, because I�m going to do it anyhow, cause it�s MY word processor), I�m going to respond genericly, but still be directed to your question. Much of the following is paraphrased from
winsouce.jpg)