Electronics Forum | Thu Jul 14 03:16:18 EDT 2022 | acouto
Thanks for the feedback, I've been having some problems with the motor overload in the conveyor and central reel whenever there is cleaning by the external company. After analyzing I always find talcum powder and lubricant (it looks like cement) on t
Electronics Forum | Tue Jul 12 17:21:34 EDT 2022 | markhoch
It is possible. If the talcum powder mixes with the chain lubricant, it could gum everything up. Back a few years ago when I was running an SMT Quattro Peak, I was having an issue with the conveyor chain drive motor going into overload. We had to pul
Electronics Forum | Sun Jul 03 03:52:40 EDT 2022 | acouto
I have some engine over load problems in the central reel, has it been identified that the external team misuses talcum powder for rubbers and many times we find talcum powder in the shafts, however will it be enough to cause the engine over load? Do
Electronics Forum | Fri Feb 23 17:35:49 EST 2001 | mattias
Ok. F.Y.I How I could make this work: We use Almit V14, and SMT ovens. You can say that we don�t do our maintenance as good as we should. Our Smt Quattro peaks are equipped with process gas cleaning (wich works quite good actually) I ripped out the
Electronics Forum | Wed Mar 27 10:56:04 EST 2002 | gregp
Alas we as Americans are destined to be innovators and consumers. However, we do not consume what we innovate. We wait for the Euro and Japanese conglomerates to take our ideas, mass produce them, and then sell them back to us. They are fueled by
Electronics Forum | Thu May 18 11:27:36 EDT 2006 | patrickbruneel
I'm not on the production floor on a daily basis like the other guys here but here's my 2 cents: With a Ni/Au plating the inter-metallic that needs to be formed is Ni/Sn. Ni/Sn inter-metallic requires higher peak assembly temperature and a longer dwe
Electronics Forum | Thu Aug 11 12:45:42 EDT 2016 | anhsang38
Dear All I have a question for the reflow machine. I'm using Vitronics(Mr933+)reflow. The peak temperature of the (Chip, LED, SOT) component higher than (QFP,LGA) about 4 degree when i measured proflie. All of them on the same board . I don't know w
Electronics Forum | Wed May 19 07:38:42 EDT 2004 | Bob L.
I'm trying to help one of our remote sites solve a problem with a warped PBGA. The corners are lifted, creating columnar joints and the central balls are sometimes shorting. I've verified that it's not popcorning and I've got samples going to the l
Electronics Forum | Wed Apr 05 16:27:40 EDT 2000 | M. Vina
Mike, I believe these are two possible sources: Peak (408) 934-2480 Eco-Tel (408) 524-7100 M. Vina
Electronics Forum | Tue May 02 07:56:58 EDT 2006 | billyd
Yeah, that's what I'm doing now. I have it now peaking around 235, with about 70 sec. above 220C. (220C is the reflow temp, according to manufacturer. I've always used 217C for Pb free) Wish me luck. Thanks!
winsouce.jpg)
