Electronics Forum | Wed Jul 07 11:40:32 EDT 2010 | daxman
Huh... Can you maybe explain a bit more? Are you getting this error on the IP3 monitor or on the programming computer? Do you use MCS, Fuji Cam or Flexa? Will the machine start up and zero-set? At which point of the power-up does the error arise? Are
Electronics Forum | Thu Jun 10 07:44:41 EDT 2010 | jdengler
Did the machine work when you first installed it? Have you done a reset start yet? Make sure you have air applied when you power up. The IP's don't like to power up without the air.
Electronics Forum | Thu May 18 23:22:44 EDT 2000 | Micah Newcomb
Jerry, Contact FujiAmerica and ask for their newest product Guide. Some differences are..... IP2 - SMD1 vision (back lighting only, coplanarity check optional) IP3 - SMD3 vision (back, front, coplanarity check optional) IP3 - BGA transport, I
Electronics Forum | Tue Jul 05 16:58:00 EDT 2022 | jdengler
When these old Fuji's do weird things I usually try a reset start. Many times that fixes the issue. Make sure you have a valid proper file before you try it. Jerry
Electronics Forum | Thu Mar 07 09:03:03 EST 2002 | cabjerk
After the IP3 is stopped by any means ie. Estop, cycle stop, or machine runs out of parts, upon restart the table will go to load position, unclamp, reclamp, read the fids and then proceed as normal. The problem is that if we already have fine pitch
Electronics Forum | Thu Mar 07 11:23:13 EST 2013 | orlando216
Yes I can move x2 axis, and check the world/zero with pulses, and it does not lose the pulses.
Electronics Forum | Tue Jun 20 19:12:41 EDT 2023 | madisreivik
Hello all ! FUJI IP3 starts up, makes zero setting OK But if I start AUTO mode, it gives error -------------------------------------------------------------------------------- Code 11082010 UsedBy MTU3,MTU4,MTU5 Display Usable Proper Data has
Electronics Forum | Fri Dec 21 09:40:40 EST 2018 | kdexter0928
I am at wits end with this machine. The MTU on my IP2 will not zero set. It gives me a few different errors depending on its mood. I receive MTU T- OT, MTU X- OT, or MTU Y- OT. when the machine attempts to zero set it travels until it OTs. I have tri
Electronics Forum | Wed Jan 19 13:30:37 EST 2011 | bvdb
The user manual says: Cause: A stick feeder part shuttle is in the advanced position where it could interfere with the nozzle. Remedy: Press the [I/O] function key and retract the part shuttle. I don't have a stick feeder. I tried resetting the I
Electronics Forum | Sun Aug 20 02:31:18 EDT 2006 | daxman
Last week, when we turned on our IP3, we received an error on our IP3, which read "Fatal Error with VP Turn Power Off" We had been running product the day before, and the day after we received this error. The function keys are locked and will not w
