Electronics Forum | Wed Feb 13 12:24:26 EST 2019 | aldrich17
Does anyone happen know where i can find an R alignment tool? Part number 5322 395 10879. Also a disassemble shaft tool. Part number 5322 395 10877
Electronics Forum | Fri Feb 15 08:31:11 EST 2019 | robl
sales@qy-smt.com are pretty good.
Electronics Forum | Fri Feb 15 08:33:41 EST 2019 | aldrich17
Thank you, ill give them a shout.
Electronics Forum | Fri May 10 01:30:11 EDT 2019 | vinitverma
You can buy directly from Assembleon (now K&S) at webshop.assembleon.com if you are a registered customer. If not, just register and wait a day for the login details. You can then buy online.
Electronics Forum | Fri Jul 09 17:52:43 EDT 2021 | glasscake
Hello, I have a Topaz-X that is losing its R origin as it runs. The issue can be seen in the following test: Set the machine to ignore vacuum/ignore alignment and have no feeders in the machine also set the nozzles all to fixed. I run a servo orig
Electronics Forum | Thu Nov 08 02:09:05 EST 2018 | vinitverma
If the nozzle gets changed properly but the machine still gives the sensor, then the FNC nozzle detection sensor needs to be adjusted. It is a set of 2 sensors on a plate on the either side of the FNC. If the nozzle is not changed successfully and ge
Electronics Forum | Tue Apr 23 09:49:18 EDT 2013 | rgduval
Thanks, Jeff. I ended up bringing someone in to help me with it. And, that's pretty much what we did. What a pain! Who ever designed these heads never expected them to fail, apparently! The actual head change out only took about a half hour (inc
Electronics Forum | Tue Mar 20 22:53:16 EDT 2018 | maustin
OK, with my masterful powers of deduction, I have been able to resolve the problem. Upon further investigation, it became apparent that the issue was restricted to those components that had the laser alignment level in the component data set to -0.2
Electronics Forum | Thu Jun 23 21:04:04 EDT 2005 | darby
If you have concluded that it is not a file storage problem you may wish to consider - When setting up a job the camera can move to virtually any position. This does not mean that the actuators on the stencil or board have enough travel to align the
Electronics Forum | Sat Jul 07 03:20:12 EDT 2012 | molder
Hi Davef ... I had been beginning for little time to work with rework station infrared, but I have a series of doubts to disclose.. could you help me? I have a Honton HT-R490 infrared Chinese station, stò trying to climb on a camera zoom lens to