Electronics Forum | Mon Mar 21 17:16:05 EST 2005 | davef
Try Radio Shack We have no significant financial interest/arrangement or affiliation with any organization/institution whose products or services are being discussed in this thread.
Electronics Forum | Fri Dec 22 05:48:29 EST 2006 | maxinorper
Hi, We have refurbished blowers. Cleaned them, changed bearings, capacitor. These parts are standard parts, you will find them in "any" hardware store and Radio Shack type dealers.
Electronics Forum | Wed Dec 26 17:40:58 EST 2007 | mobytahoe
Hey Andy, Thought you were buying a line? Do some homework, bro. This is manufacturing...not building a crystal set to listen to a.m. radio...
Electronics Forum | Fri May 13 03:58:49 EDT 2016 | philc
Have a look for your local amateur radio club, or electronics hobby club, and pop along with it. Both will have folk that can do the soldering for you..... Good luck!
Electronics Forum | Mon Nov 26 20:30:03 EST 2001 | davef
Dirt => Beer => Girls FACT: * Hybrid circuits in the 1960s that were used to conquer space where the genesis of today's SMT. * Japanese commecialized it to build better transitor radios * UIC & Dynapert fought it tooth and nail. UIC finally got t
Electronics Forum | Mon Dec 09 17:02:50 EST 2002 | jonfox
We currently have a factory radio that plays through speakers in the ceiling. It becomes an issue from time to time over the current format that is playing (especially during the holidays). If quality does not become an issue and there is no hand m
Electronics Forum | Tue Dec 17 07:22:06 EST 2002 | Claude_Couture
Ever been in one of those "rolling boombox" with the thumping bass shattering every windows a mile around? Those should be illegal, if only for the fact that the brains of the occupants is turned to jelly by the decibel levels. But my point was usin
Electronics Forum | Thu Jul 22 15:15:24 EDT 2004 | russ
You can purchase pad repair kits at some "radio shack" type stores or you can order them from some such as Circuit repair corp. If you know where the signal traces go from the individual connector pins I woul;d recommend just adding a wire frm the p
Electronics Forum | Thu Dec 02 17:29:35 EST 2004 | resslerr
Sony has a system which is used in all its factories worldwide. With this system, you can check the actual production condition, and more, anytime over the web or you can have the system find you via radio, pager, phone, e-mail to provide you the st
Electronics Forum | Tue Jun 20 00:31:18 EDT 2006 | Frank
I, too, would bend it 90-degrees prior to assembly and I would also put on a little spring loaded, removable, heat sink on to the wire to stop the heat transfer up the wire. After the wire is soldered, then remove the heat sink. Try the one from Ra
