Electronics Forum | Tue Jan 24 08:01:32 EST 2012 | wolverine
When using the rectangular plate given with the machine that is used with calibrating the movable camera, does the longer side of the plate get fed into the machine ( rails set to 80mm ) or the shorter side ( rails set to 74mm ) Thanks Dave
Electronics Forum | Wed Jun 19 10:11:59 EDT 2019 | jamesn
Hi to everyone I hope someone can help me with a problem I have on a Quad QSP-2. when calibrating ( Or trying to use ) Feeder Bases 2 and 4 on gantry 2 Im getting small amounts of accumulative drift in the X axis. I have changed the servo amplifier
Electronics Forum | Fri Feb 19 11:13:02 EST 2016 | ttheis
I'm setting up a product for the first time on my GSM after I completed debugging some other issues. The previous owners had the PWC axis disabled and the axis motor disconnected, so I re-connected it and enabled it and now it homes and moves. When I
Electronics Forum | Wed Feb 23 20:48:14 EST 2022 | dekhead
MAINTENANCE, DIAGNOSTICS, RAIL SYSTEM, BELT SPEED CALIBRATION
Electronics Forum | Tue Oct 09 11:42:42 EDT 2012 | cyber_wolf
Actually the correct way to fix this is to carefully remove the belt on the rear of the machine that connects the left and right rail lead screws together. Square the rails then carefully re-install the belt *without turning either of the lead screws
Electronics Forum | Tue Nov 15 16:57:22 EST 2005 | bk
If your problem is happening part way through the calibration the problem might be there is too much friction from your Y-wagon. Measure the friction on the Y-wagon using the service program if it fails or if it is near the max allowed try oiling up
Electronics Forum | Mon Apr 05 09:33:42 EDT 2010 | flanz
Hello. I'm new to the group and would like to ask a question about a YTV-2000 that I have. Question is - Could someone explain why my Yestech 2000 has a hardtime with calibration? What happens is that I run calibration before I start a new board.
Electronics Forum | Tue Jun 06 13:47:10 EDT 2023 | oxygensmd
In Hungary there are many EKRAs. Bosch, Zollner and many big/small company are using them. I also saw the latest DEK but I think DEK is over-complicated, fast and good printer - but if you have any problem, it cost a lot. MPM also nice machine but I
Electronics Forum | Tue Jun 06 14:26:00 EDT 2023 | spoiltforchoice
> In Hungary there are many EKRAs. Bosch, Zollner > and many big/small company are using them. I also > saw the latest DEK but I think DEK is > over-complicated, fast and good printer - but if > you have any problem, it cost a lot.
Electronics Forum | Sat Feb 27 00:59:43 EST 2010 | jmelson
Hi, I have a CSM84, PA1306/20. When I got it, a lot of the offsets had been zeroed out. I figured out a procedure to calibrate the back feeder rail, but haven't come up with a scheme to calibrate the mechanical alignment unit. I have it close, but