Electronics Forum | Sat Jun 26 21:17:34 EDT 1999 | Bob Huelsenbeck
Anyone having any conveyor rail shaking on Electrovert wavesolder machine model "Electra"? The conveyor shakes more with a pallet passing through the machine, particularly when the 20" pallet is passing from spray fluxer to the first pre-heater. Here
Electronics Forum | Mon Mar 20 08:36:30 EST 2006 | jdengler
I've never had this problem on an Omniflo oven, but have seen it on others. It has always turned out to be mechanical. A bearing going bad or FOD in the rails. I would pull the chains and carefully check each link of both chains, all of the bearin
Electronics Forum | Tue Mar 21 07:31:54 EST 2006 | cyber_wolf
We had the exact same problem on our OMNI 10. We found that two of the rails the pin chain rides in were warped. Somehow at one point our PC lost communication with the oven and the heaters went wide open for several minutes...this is what caused th
Electronics Forum | Mon Jul 17 16:29:18 EDT 2006 | aj
Rail widths are fine. The board loads from the previous conveyor and hits the down stop and flags the sensor... It will sit there and time out unless I flag the left rail sensor. It will work properly every now and again. All sensors work fine in t
Electronics Forum | Fri Jul 21 13:13:53 EDT 2006 | vikkaraja
I have checked the lead screw and guide rails. There is't any apparent damaged to any one of them. I was hoping it be the guide rails because they are much eaier to repalce than the lead screw. If I start messing around the lead screw, It would requi
Electronics Forum | Thu Feb 22 23:27:14 EST 2007 | dekhead
If protocol is already manual, does conveyor start when "RUN" is pressed (without board on rail)? Or does it not start until board is placed? Try running UL protocol as "No FMI", put in run without board on rails, place board, press "Confirm". Board
Electronics Forum | Mon Mar 17 11:09:36 EDT 2008 | swag
You might also try pulling the vision gantry and/or the camera cube off the machine, remove the air nozzles, clean them, and reinstall. They are easy to lose - be carefull. It's possible the air hockey "air pad" that these things are riding on is u
Electronics Forum | Thu Oct 30 09:23:34 EDT 2008 | jwolvans
Hi, Rob. Does the table appear to hang up, then suddenly let go? If so, check the alignment of all four conveyor rail guide blocks, especially if the clamping rails have been recently removed for maintenance. After that, check the piston assembly t
Electronics Forum | Wed Jun 10 01:21:40 EDT 2009 | mikawi
So I got to work today. They asked me to finish removing all the parts for the CBS (center board support). While doing this I removed A Tor Tender tolomatic 1/2 inch gear box from the shaft that widens the rails. It is used to link the front and rear
Electronics Forum | Fri Jun 06 17:47:14 EDT 2014 | hegemon
SWAG has it. Carriers for SMT are a great idea, especially to mitigate sag, and allow some savings in setup. Fixturing setup advantage: You could fixture everything to a fixed width, and eliminate rail setups throughout your lines. Trade off the f
.gif)
