Electronics Forum | Wed Feb 20 16:03:19 EST 2013 | bocci572
I am wondering if anyone has had issues with their Heller oven rails warping. It appears that our 1800EXL and 1900W oven rails sag after time. They eventually contact the safety mesh and then create hestitation of the chain, thus creating defects.
Electronics Forum | Thu Feb 21 06:18:42 EST 2013 | cbeneat
We run 3 Vitronics XPM2's, our newest is 3 years, oldest is 6+ and I have not seen our rails warp the way you're describing. I would be plenty frustrated if I had to replace rails this often.
Electronics Forum | Wed Feb 27 11:20:15 EST 2013 | marcpeo
Sorry to hear of the difficulty with the rails on these systems. The 2 machines mentioned are 10 years old or more. The rails typcially last quite a while but replacement after 10 years is possible. Please feel free to e-mail me directly to discus
Electronics Forum | Thu Feb 21 08:52:24 EST 2013 | emeto
Currently having Elecrtovert and BTU - no problems with both. Before use to have Vitronics aand Heller - and no problems with the rails. However I had other problems with Heller which makes me think that they are going deeper with the bad quality par
Electronics Forum | Fri Mar 08 16:30:53 EST 2013 | pctech
We have 1880 Heller about 12 years old and running like a charm everyday. I doubt that lead or non-lead operations will have anything to do with it. Do you use high temperature lubricant on edge hold chain and rail periodically? This may help to ease
Electronics Forum | Fri Jun 04 04:10:52 EDT 2010 | leeg
Have you checked the Rail Lifted Sensor
Electronics Forum | Mon Jun 19 10:46:53 EDT 2000 | D.J.
Does anyone out there have a Vitronics SMR400 or SMR410? Trying to get facilities specifications for amperage at 208 vac, and also any information for rail adjustment procedure for dual rail. Did Vitronics offer fixed tooling rail adjustment, are t
Electronics Forum | Mon Jun 19 10:46:41 EDT 2000 | D.J.
Does anyone out there have a Vitronics SMR400 or SMR410? Trying to get facilities specifications for amperage at 208 vac, and also any information for rail adjustment procedure for dual rail. Did Vitronics offer fixed tooling rail adjustment, are t
Electronics Forum | Fri Jun 04 02:51:25 EDT 2010 | tomta
We have a DEK 265 printer currently down due to the rail system error. The message "Belt Motor Error. Rail lifted error, check tooling" pop-up when pressed run. I did remove all the support pins prior loading a new job. I also ran rail system dian
Electronics Forum | Wed Apr 09 03:32:49 EDT 2014 | sarason
Place a Digital CRO on that 24V rail. Watch the output. trigger on voltage drop lets say 18V picking a figure out of the air. You may well have another rail in your supply or nearby pulling your 240V //110V rail. Most likely a shot Electro either on
.gif)
