Electronics Forum | Fri May 29 07:17:30 EDT 2015 | kkay
We have a small board about 1" by .5" and it is .012" thick. It is in a 50 up panel. We have tried rat bites and v-score and we keep seeing delamination around the edges. Anyone have experience depaneling boards this thin?
Electronics Forum | Thu Jun 18 22:25:24 EDT 1998 | Dave F
| | | | | We're running into problems with board damage (broken traces, solder shorts) due to pliers and other bizarre tools being used for depanelization. I need some sort of fixture for this. A delrin plate with a slot cut to the correct depth and
Electronics Forum | Wed Jun 10 09:27:36 EDT 1998 | Steve Gregory
| We're running into problems with board damage (broken traces, solder shorts) due to pliers and other bizarre tools being used for depanelization. I need some sort of fixture for this. A delrin plate with a slot cut to the correct depth and width mi
Electronics Forum | Wed Jun 04 18:46:10 EDT 2014 | hegemon
Well, we cannot make the cuts any deeper as then > we would incur a significant amount of "bowing" > at SMT placement/reflow. Interesting. Could be a number of factors contributing. Here's a story.... In the beginning was the board design, and in
Electronics Forum | Thu Jun 18 15:04:48 EDT 1998 | smd
| | | We're running into problems with board damage (broken traces, solder shorts) due to pliers and other bizarre tools being used for depanelization. I need some sort of fixture for this. A delrin plate with a slot cut to the correct depth and wid
Electronics Forum | Thu Aug 22 22:10:26 EDT 2002 | davef
Ooooow! �Can it be fixed?� Good question. How BAD did you damage it? * Since you are asking this question, I am NOT inspired by the potential that you have the skills to fix the board. Go Jeff Ferry�s site at Circuit Repair Center [If you can�t f
| 1 |
winsouce.jpg)