Electronics Forum | Mon Oct 10 15:24:15 EDT 2005 | zl3vlf
Hello to all! Our Fuji FIP-3 placement machine has come up with a servo alarm (X2-axis) whenever we try to run the machine. The manuals don't go into a lot of detail as to the cause of this problem, but there is plenty of information on what the X2
Electronics Forum | Mon Aug 31 11:52:28 EDT 2020 | inspiredmorris20
Hello Jon, I appreciate your reply, correct there are 2 red (24v) that control the main power and 2 blue (they control the power to the units operation keys ready, start, stop, reset, change feeders.) additionally there is a red jumper wire on the E
Electronics Forum | Fri Aug 28 17:47:59 EDT 2020 | inspiredmorris20
thanks Stephen!! I'm testing for voltage and have found 24v going through the E-stop to the main switch. If i trip the E-stop i can disengage the main switch. I have no more control to the hardware then that. The software is not throwing any code ot
Electronics Forum | Wed Jan 31 13:00:43 EST 2007 | bvdb
The continuing saga - we got the IP-1 communicating with the MCS16 again by replacing a couple of chips on the VME1152 CPU board and now it's working again but have a new problem. The machine stops about every other time when changing nozzles with a
Electronics Forum | Fri Sep 24 06:17:47 EDT 2010 | bullyparade
Hi all, we use a MPM UP2000/B printer and facing the following problem: During startup/initialisation process the printer stops after a while and comes up with the following alarm "hardware limit warning". This can be repeated several times with the
Electronics Forum | Thu Feb 01 02:36:40 EST 2007 | bvdb
Hi pr, The problem was happening on all three of the nozzles that we were using, about half the time the Z axis would rise up and go for the next nozzle and the other half it would stop almost as soon as it released the nozzle. When I inch the Z ax
Electronics Forum | Thu Apr 26 02:32:44 EDT 2018 | bukas
1. check both e-stop buttons are released 2. reset e-stop with blue reset button 3. open Alarms menu(there is icon) 4. acknowledge alarms(next to alarms menu icon) 5. clear alarms(next to acknowledge alarms icon) 6. go back to operating interface(thi
Electronics Forum | Fri Apr 08 05:22:47 EDT 2005 | Bored
The light events are: Red - Alarm - Indicates that an alarm exists.This also occurs when the emergency power stop button has been used to stop the belt and turn off heater power. Orange - Alert - Indicates that an alert condition exists. Green - R
Electronics Forum | Fri Aug 20 12:06:53 EDT 2004 | danhui888
Pls contact ECD for built in monitoring system or KIC 24/7. This products will monitor your oven performance and profile round the clock without stopping. If your profile is out of the spec, the software will gives you an alarm and the machine will s
Electronics Forum | Fri Aug 20 12:06:55 EDT 2004 | danhui888
Pls contact ECD for built in monitoring system or KIC 24/7. This products will monitor your oven performance and profile round the clock without stopping. If your profile is out of the spec, the software will gives you an alarm and the machine will s
.gif)
