Electronics Forum | Mon Aug 18 06:30:23 EDT 2014 | nhel_0009
Hi guys. Kindly help me on our reflow (vitronics soltec). My problem is the n2 value reach 10014...any possible solution or suggestion guys..
Electronics Forum | Mon Aug 18 06:35:44 EDT 2014 | nhel_0009
Hi guys. Kindly help me on our reflow (vitronics soltec). My problem is the n2 value reach 10014...any possible solution or suggestion guys..
Electronics Forum | Mon Sep 08 10:32:39 EDT 2014 | nhel_0009
Right sir we already fix it by loading configuration from other machine
Electronics Forum | Mon Sep 08 09:11:30 EDT 2014 | jdenuzzia
We resolved this issue a few weeks ago. It was a configuration mismatch in the oven (MR933+)software with the onboard O2 analyzer.
Electronics Forum | Mon Oct 22 08:27:49 EDT 2018 | filipblad
Hi, We're having issues with our mydata tp9 pick'n place. It doesn't go all the way down on the tool, so it can't pick it up or install it. The fault code I get when trying to install tools is F-TLMN-18: Can't reach tool bank. Any ideas? I've comp
Electronics Forum | Mon Oct 22 16:33:14 EDT 2018 | tey422
To narrow down the cause. Have you test it on all your tools? If only particular tool(s) having issue, then it might be tool that's having the problem.
Electronics Forum | Tue Oct 23 00:52:16 EDT 2018 | filipblad
Yes, for all tools... The tool head stops just above the tool
Electronics Forum | Tue Oct 23 11:18:23 EDT 2018 | tech1
It is probably one of the Z lock solenoids not working properly. These are located along the Z axis and as part of the initiation of the machine, the Z measure the travel. Check the upper and lower Z locks
Electronics Forum | Wed Oct 24 00:36:59 EDT 2018 | filipblad
I've checked the locks in the service program and the solenoids move when told to.. also I can see them opening when going to pick up a tool..
Electronics Forum | Wed Oct 24 07:33:44 EDT 2018 | tech1
when the machine initiates the last move it does is in the Z axis. If memory serves me, during the last Z move it drives down and measures the stroke, if the lower solenoid is not fully retracted the axis measures the wrong travel limits. Hopefully t
.gif)
winsouce.jpg)
