Electronics Forum | Tue Feb 25 03:32:58 EST 2020 | bukas
hello guys, I got a problem with MAIN START switch on Samsung CP45FV NEO. The switch itself works, and it activates contactors #1-1 #1-2 and #3 but after pressing READY button there is en error msg reporting that MAIN START has not been pressed. Alre
Electronics Forum | Thu Aug 12 06:46:35 EDT 2021 | bukas
there is no, error $0022 in technical reference. is the error you are getting a EMER level? if so there is probably a safety sensor or switch that is causing this error. $0021 is related to door switch so I would go from there. do you have technical
Electronics Forum | Wed Aug 11 12:41:05 EDT 2021 | jamesatqkits
Hi Bukas, Thanks for getting back to me. What is the IF board? Is that the Interface Boards in the cage? How do I know if I have a healthy hard drive? Is there anything in particular to look for? I will run chkdsk today and see if it reports any
Electronics Forum | Thu Aug 12 12:50:14 EDT 2021 | jamesatqkits
Hi Bukas, Err 22 shows up on the Panasonic motor driver in the back. I purchased this machine used. I have never had it operating in my shop. I checked the output of the transformer, 110 V output is 97 220 is 197, so I checked my input its 200 (machi
Electronics Forum | Tue Oct 17 09:26:55 EDT 2023 | georgegr777
Thank you , I checked the green button. When I pushed it I can heare the relay noise and the LED between green and red button is on. But when I push the READY switch it is not responding. As for the email the gmail server send me back information th
Electronics Forum | Fri Aug 28 12:46:04 EDT 2020 | inspiredmorris20
Greetings all, my cp45 pnp machine is down this morning, gives me the code 0002 (front EME switch pressed). operator said they did not E-Stop, reset the unit and reboot the S/W a few times. the code pops up as soon as the software loads. I can turn
Electronics Forum | Fri Aug 28 17:47:59 EDT 2020 | inspiredmorris20
thanks Stephen!! I'm testing for voltage and have found 24v going through the E-stop to the main switch. If i trip the E-stop i can disengage the main switch. I have no more control to the hardware then that. The software is not throwing any code ot
Electronics Forum | Thu Jul 03 03:12:59 EDT 2008 | bizbonk
Point is lead free is a fact for many of us, whether we like it or not. We can all agree upon the fact that it is forced upon us for the wrong reasons. Doesn't change the fact that The majority of our colleagues in Europe and Asia have to make this w
Electronics Forum | Fri May 03 18:10:17 EDT 2002 | stownsend
Okay, here goes another thread about gold plating. I have been using gold plated PCB's for about two years now, with mostly very good results. The main reason I started using gold in the first place was because it is flat, solder wets to it nicely,
Electronics Forum | Fri May 21 17:41:01 EDT 2021 | jamesatqkits
Hello, This is my first time posting to this forum, or forums in general, so go easy on me. I have just acquired a CP45FV NEO, "My other car is a CP45FV NEO" anyways, when I try to put the machine into ready mode I get the error, [0006] I/O power
