Electronics Forum | Tue Jun 30 18:07:34 EDT 2020 | daisy_mu
Hi Phill Thank you, It´s a possibility because that model has many false calls and real defects, but only in one component. A while back we had a similar problem and we changed the component number to a new one, and the cycle time was better, but th
Electronics Forum | Fri Dec 02 09:12:20 EST 2005 | chunks
We have both Ersa scope and X-Ray. Everyone uses the X-ray because it's a quick way to check for shorts, which seems to be the line supervisors only concern when it comes to BGAs. The Ersa is fine, but it's only real use is to examine a couple of r
Electronics Forum | Wed Aug 25 19:35:48 EDT 2004 | russ
This is highly dependent upon your board, vision inspection, part rotation, part type, layout, number of P/Ns per (1 pers or 100 pers) feeder layout, optimization, nozzle changes, etc... all have significant impact on placement speed. I find if you
Electronics Forum | Tue Dec 06 22:48:04 EST 2005 | minimicro
Mike You are my hero. A real world person.
Electronics Forum | Wed Dec 14 06:18:20 EST 2005 | tk380514
right again grant, consider the fact that if you spend enough time inspecting the soldered boards/pre-oven and check the BGA solder paste pads before, and clean the stencil regularly and check solder paste dryness, check oven profiles then after chec
Electronics Forum | Wed Dec 14 12:57:23 EST 2005 | grantp
Hi, Wow, that's cheap. I did not know they were available that low cost, and we had been quoted much higher for the Ursa scope, so that's why I thought why bother, and lets put it into xray. I bet Superman would have a terrible time working in an S
Electronics Forum | Fri Dec 02 18:37:46 EST 2005 | Ola
What is the quality worth to You? How much is "to much" for You to spend on a good quality ckeck? How much benefit can You get in return, If You in the first place get the processes straight? These are the main questions that You have to answer Yours
Electronics Forum | Wed Dec 14 06:58:29 EST 2005 | jdumont
We have a version of the SMT Tools scope. We use it hand held style with no stand (much easier). We also find that it is not used very often. XRay and a reliable process are more important to spend the time and money on. This is a good tool to have f
Electronics Forum | Thu Dec 08 08:12:03 EST 2005 | grantp
Hi, That's my thoughts, and I just don't know what looking at the component will do for the process. I did not know anyone used anything other than no clean flux these days. If you have the money, then the scope would be fun, but my main point is
Electronics Forum | Thu May 30 10:31:03 EDT 2002 | robbied
Hi Yannick. This is an issue that we are just recently getting into but here is some ifo that I have gathered so far. I have seen/ used 2 different rework machines. The one we have bought is a 'PACE TF2000' which was at the lower cost end of the mar
Our Company handle AOI (Auto Optical Inspection) and SPI (Solder Paste Inspection) Machines.
Equipment Dealer / Broker / Auctions
Hwaseong-si, Gyeonggi-do, Korea
Hwaseong-si, South Korea
Phone: +82-1029254936