Electronics Forum | Wed Feb 23 15:24:24 EST 2000 | Michael Uganecz
Steve, Give MPM/Speedline a call and see if they still sell the SPM-AV, it's a shuttle style printer with vision alignment. It has a really nice auto-align vision system that will move the table in x,y and theta. It's not a look up/look down syste
Electronics Forum | Wed Feb 23 15:24:24 EST 2000 | Michael Uganecz
Steve, Give MPM/Speedline a call and see if they still sell the SPM-AV, it's a shuttle style printer with vision alignment. It has a really nice auto-align vision system that will move the table in x,y and theta. It's not a look up/look down syste
Electronics Forum | Tue Oct 09 11:17:24 EDT 2018 | dfl
Ok, I will try and post the result. thanks for the help!
Electronics Forum | Tue Feb 22 19:21:05 EST 2000 | Peter
I like MPM's 500 machine. I purchased the predecessor model when it was made by SMTech. This machine has programmable pin supports which made setting up for double sided boards really easy. For auto alignment, I think only in-line machines have th
Electronics Forum | Tue Feb 22 19:21:05 EST 2000 | Peter
I like MPM's 500 machine. I purchased the predecessor model when it was made by SMTech. This machine has programmable pin supports which made setting up for double sided boards really easy. For auto alignment, I think only in-line machines have th
Electronics Forum | Tue Oct 09 05:38:29 EDT 2018 | dfl
Hi, my Quad IV-c is showing a really dark image on the camera and its VERY difficult to see the components pads to make the adjusts. I already check the monitor brightness (at maximum and I can see the crosshair, so the monitor is good) and already
Electronics Forum | Tue Feb 22 17:03:48 EST 2000 | Chris
Dek 249 and Dek 260 models use to have fiducial recognition where table would adjust to the stencil. However, I would still recomend you buy an inline model because the change over will be much faster. Probably 10 times faster.
Electronics Forum | Tue Feb 22 17:03:48 EST 2000 | Chris
Dek 249 and Dek 260 models use to have fiducial recognition where table would adjust to the stencil. However, I would still recomend you buy an inline model because the change over will be much faster. Probably 10 times faster.
Electronics Forum | Tue Oct 09 06:14:48 EDT 2018 | bobpan
Move the camera over a feeder position and shine a flashlight to see if the image improves.....if it does....your light ring needs replaced or the led's need replaced in it. Sometimes just re-adjusting the angle of the led's in the ring can help. Go
Electronics Forum | Tue Oct 09 10:52:57 EDT 2018 | bobpan
re-adjust them .....yes just bend them in a little more. As for led's ....i have tried all kinds...some work better than others.
