Electronics Forum | Tue Apr 21 21:30:59 EDT 1998 | Jon Medernach
I, for one greatly appreciate the free and open forum! You must have a balance between those who are (at least in their own minds) process experts and the "sales weasels". Is a consultant who uses the NET to promote their business any different t
Electronics Forum | Fri Mar 19 07:59:20 EST 1999 | Thomas Nocpen
Having been a FUJI line support engineer for years at my company, I was asked to evaluate the new Fuji feeders by our local Fuji rep. We have been using the Hover MPF feeder for the past 3 years and have had virtually no issues with them. The operato
Electronics Forum | Mon Sep 09 21:58:34 EDT 2013 | mandysmile
there is another reason, find the reason from the base material.
Electronics Forum | Tue Feb 29 21:18:00 EST 2000 | Gwen Z
When an assemblied board was on active service, what's the main reason for its failure:the package broken; the mechanics fatigue failure under thermal cycle; the corrosion caused by salt and vapor; the broken chip inside the package etc. I think all
Electronics Forum | Tue Feb 29 21:18:00 EST 2000 | Gwen Z
When an assemblied board was on active service, what's the main reason for its failure:the package broken; the mechanics fatigue failure under thermal cycle; the corrosion caused by salt and vapor; the broken chip inside the package etc. I think all
Electronics Forum | Sun Jul 20 09:05:33 EDT 2003 | davef
A reasonable request should receive a reasonable response. * If you request a failure analysis and corrective action, you should get one from your manufacturing group. * If you desire a detailed understanding of failure, you should use an outside gro
Electronics Forum | Thu Mar 15 21:14:33 EST 2001 | davef
Well Cal, we all had better be sales types. [Otherwise our bosses might question our reason d'entre, eh? My good looks only carry me so far.] I think as long as the sales types are adding content there is no reason to complain.
Electronics Forum | Mon Dec 13 14:13:39 EST 2004 | Gary
We are setting up our criteria for acceptance of solder voids. We would like 2% to 4% or smaller as our tolerance. Does this sound reasonable? Are most x-ray machines able to accurately measure at that size? Also, do most people find that 2% to 4
Electronics Forum | Tue Apr 19 07:37:48 EDT 2005 | mirrindolan
I am looking for all the reasons why operators and stores must let solder paste reach room temperature. I am trying to make it is as easy as possible for everyone to understand. I have compiled all the obvious reasons but I am open to all comments an
Electronics Forum | Mon Jan 09 11:26:08 EST 2006 | abhinavajmera
Dear Grant, Thank you for the reply. It is really a valid reason and I did check for it but nothing turned out that way. Can you think of some other reasons if the process parameters are the same used earlier when there was no problem at all. Regard
