Electronics Forum | Sun Aug 13 10:49:23 EDT 2023 | kirill
Usually, for big connectors like this, you can use a red smt glue under the connector with a dispenser. If its not possible, you can use the same red glue and put a small dot on the side of the connector after reflow, and heat it a bit with blower, 1
Electronics Forum | Mon Jul 31 07:37:57 EDT 2023 | tommy_magyar
Hi Simon, Yes, red glue should help, assuming that it is being dispensed by a glue dispenser. For stencil printing I used yellow glue in the past (can't remember the brand). Your pick and place machine should be able to achieve on it's own 35 um
Electronics Forum | Tue Feb 11 01:24:54 EST 2020 | jineshjpr
Dear Team, Is there any body used GLUE +IR-130 SMD Adhesive for Connectors?? What is the specialities of this adhesive as compared with PD555 SMD RED Adhesive??
Electronics Forum | Tue May 20 11:09:30 EDT 2003 | JB
Hello Gav, We have tried the procedure that you described, and it didn't work well for us. Even though the viton tubing is doubled up and pinched, no amount of glue is visible at the tip of the tubing. So getting the glue to protrude from the syring
Electronics Forum | Tue Jul 13 16:29:25 EDT 2021 | stephendo
I didn't see that but I was thinking he could sprinkle it with holy water and repeat in a loud firm voice, "the power of Christ compels you". Or he could find an IT forum instead of a manufacturing one where our printers use a stencil and print bric
Electronics Forum | Thu May 26 11:21:14 EDT 2011 | asksmt
Hello Guru's, I am using IPC-7351 LP Calulator to design Footprint (0603, 0805, 1206, SOT-23, etc) for all SMT Parts. Our Production Recently commented that they have included Red Glue Machine inhouse and will use Wave Soldering for Both Thru-hol
Electronics Forum | Tue Nov 24 10:03:45 EST 2009 | andrzej
Actully none couse we glue them. Please see attached file - there are red dots marking glue placment. I understand you want to check if there is any sense in gluing components. I`ll ask one more time - Is anoyne who reworked SMDs with SAC305 where
Electronics Forum | Thu May 26 13:13:20 EDT 2011 | blnorman
Hopefully the experts can help you out. I can just say you have to be very careful not to get the adhesive on the pads. So I can understand making sure there is enough distance between pads so the adhesive doesn't interfere, not sure about increasi
Electronics Forum | Thu Sep 11 15:23:31 EDT 2003 | Peter L.
I have come across a rash of failed assemblies that have 0805 capacitors and resistors, bottom side glued, wave soldered and washed. Trouble shooter reported touching up the solder joints on a few areas and the boards would pass test. I had a look a
Electronics Forum | Wed Oct 30 10:55:53 EST 2002 | ahobby
I hope you'll take an answer from the sunny UK. I don't usually read these forums but contribute to similar over here, hence the late response. We have an Invicta Sabre 757 machine in our Demo room, running with Zestron SD 300. We give the PumpPrint
winsouce.jpg)
