Electronics Forum | Wed Jun 28 22:42:34 EDT 2023 | unsung
I work on a few of these Universal machines before. Check your severos ( I believe their 6 of them ) in the back of the machines all of them should be on. If you see a red light on one of them it's gone bad and that's your Y axis card. It's easy to
Electronics Forum | Mon Jul 30 10:22:57 EDT 2007 | swag
Sounds like your board stop sensor is not working properly so it's not seeing the y-stop/board edge when the board enters the center or the machine. You could try taking the camera cube cover off, jog the camera over a board then move the board back
Electronics Forum | Mon Sep 28 10:51:02 EDT 2009 | shanenaturalpoint
My company recently purchased an MPM AP27 on the used market. I had the machine up and functional at one point, but now it is inoperable. I have correct power and air to the machine, but when I attempt to power it up, I get nothing. Red light on t
Electronics Forum | Fri Jul 04 03:54:10 EDT 2008 | aj
Hi all, The cognex card in the GSX failed to boot up during power up. The card displays the dreaded red light on the diagnostics LED. I got a quote from Dek and I think I cold buy a 2nd user machine for the same price. So my question is - can I g
Electronics Forum | Wed Sep 01 14:59:12 EDT 2010 | eezday
I've been working to bring a Universal GSM-1 back to operational readiness at a university. I have lots of pnp experience but little on the GSM. The software is at 3.2.3. When I try to manually "zero the board" in the PWC menu I get only a black s
Electronics Forum | Mon Aug 05 14:13:09 EDT 2013 | rway
I haven't done this either but have an idea of how I would address it. First, let me ask, are your leads crimped or straight? Most likely they are crimped which means you should get reflection from the lead. You could try a solder inspection (reve
Electronics Forum | Mon Mar 16 12:10:59 EDT 2020 | emeto
Katrina, it is one of both: 1. Communication error - try to initialize machine with line controller OFF. This should tell you if machine can initialize on its own and if the problem is on the machine. Try without the feeder carts, look at the cards
Electronics Forum | Tue Nov 15 19:31:54 EST 2005 | eeltec
>I/OPERATION ==> >1/RUNNING ==> but any command that I try gives an E100 error and in the left side of the monitor a square with: Conditions Initialized Waiting Emg stop (in red) org incmp (in red) Interlock (in red) data comp Use Vac
Electronics Forum | Fri Jul 07 12:42:42 EDT 2023 | ttheis
We checked the three pacsci pc800 servo controllers and they all look OK, no red or error lights. VRM amps all look OK. Still haven't found the issue.
Electronics Forum | Wed Sep 11 18:01:27 EDT 2013 | huske
I've had that issue before, here's how you fix it, or at least it worked for me. Also assuming you didn't destroy a shaft, which should be obvious. Follow the flexible vacuum tubes to the top of the hydra shafts, you should see a red light below the
