Electronics Forum | Wed Jun 13 01:01:10 EDT 2012 | isd_jwendell
I clean all fids with a fiberglass brush pencil so that I know there will be no rejects (it doesn't take too long). The problem is the machine lighting. My Essemtec machine uses a light ring (red LEDs) around the cam. Here's one of many documents th
Electronics Forum | Fri Feb 10 12:09:53 EST 2006 | cyber_wolf
Russ, We use a unit called a Datapaq surveyor to monitor our ovens. Its basically a unit that a data logger rides through the oven in. It has 3 thermal couples across the top and 3 across the bottom. It takes measurements the full width of the proces
Electronics Forum | Mon Aug 27 15:13:48 EDT 2007 | davef
Rob When the little light goes red, your supplier changes your ion beds. How does he determine when to change the carbon bed? Carbon certainly won't go bad as fast as the ion beds. Right?
Electronics Forum | Thu Aug 30 19:39:15 EDT 2007 | davef
Rob If your supplier replaces your carbon bed when the ion beds require replacement [when you call after the light goes red], it will not hurt anything, except increase your costs.
Electronics Forum | Wed May 08 10:40:48 EDT 2013 | huske
We have had this problem before, and Phil was pretty close. On the hydra where the vacuum tubes are connected to the tools shafts you should see a red light inside there. this light locates a lazer cut mark on each of the tool shafts, this lets t
Electronics Forum | Mon Oct 13 16:32:55 EDT 2014 | tombstonesmt
Designator>Part Number>Alternate. 2D labels are placed on all slots of the machine, operator scans slot, scans reel with unique material ID. Green light if it's good, red light if it's bad. Our software cannot lock out a machine if there is an incorr
Electronics Forum | Tue Apr 16 09:46:36 EDT 2019 | ttheis
We just bought a MVP Supra M machine and have put it under power but can not get the PC system to power on. I am following the power up procedure in the manual. Under power the conveyor controls work and the UPS backup turns on, but holding the key i
Electronics Forum | Fri May 11 14:54:38 EDT 2012 | stentech
I am not aware of the Nano protek flaking off. However I do believe it can wear off through abrasion. Unforunately there is no red light goes off when it has worn unless you have good paste inspection. Even when it wears it will not take you to a neg
Electronics Forum | Tue Mar 17 16:27:32 EDT 2020 | sportsradar
With LC off, the machine when told "Without LC" will zero set. It displays Error 746. After zero set, turn LC on, and it hangs up. Error 746 is IEC blocked, solutions Reboot machine and PC. And we know, rebooting isn't getting me anywhere. What car
Electronics Forum | Tue Jan 05 21:24:34 EST 2021 | rmitchell
We use to have to replace the "dog" tube when it got rounded out or worn a little. If you you already cleaned it and can see the red light going off and on when you gently push up on the nozzle it is just not seeing in time and it gives the nozzle c