Electronics Forum | Mon Jan 15 15:40:18 EST 2007 | pyro747
Having problem with a 2X50 SCKT Strip PTH component(fine pitch) bridging on the wave. The PCB runs in wave pallets. Just wanting to know what successful findings have been done to eliminate bridging? Pallet angles? Copper or titanium inserts? Air kni
Electronics Forum | Tue Jan 16 20:44:07 EST 2007 | davef
Bridging Causes: Insufficient flux, Excessive pre-heat, High conveyor speed, Solder contamination Look here: * http://www.smtnet.com/library/files/upload/Reflow%20Wave%20Poster.pdf * http://smt.pennnet.com/Articles/Article_Display.cfm?Section=Archi
Electronics Forum | Tue Jan 16 16:59:39 EST 2007 | realchunks
Pallet angle is usually pretty good. Lead length is also another good thing to keep as short as possible. Air Knives don't work that well. Also check your board. Make sure you have solder resist between each and every thru-hole pad. If the board
Electronics Forum | Wed Jun 03 15:45:36 EDT 2015 | ldempsey
Well, it took me a while but I had a look at some gerbers. On a PCB with neighboring 0402's 0.006" apart, and paste reduced 0.75mil on each side, I get lots of bridging. On a later rev of the same PCB, we have neighboring 0402's 0.018" apart,and pa
Electronics Forum | Tue Jun 02 17:32:53 EDT 2015 | jldowsey
Les, Some of the answers to design or stencil aperture/placement machine depend upon what is the current spacing between your components which you didn't specify. Chip components such as 0402's and 0201's typically have very small reductions in pas
Electronics Forum | Tue Jun 28 13:04:08 EDT 2005 | slthomas
Are you saying that increasing the frequency of cleaning to every 3 boards *reduced* bridging, or that it's just something you tried? I don't understand why that would help(in my experience it has reduced "insufficient solder" conditions but not brid
Electronics Forum | Sat Jun 25 10:04:08 EDT 2005 | ktron
Hi MSK, Stencil thickness: 5mils with laser cut Smallest pitch: 20mils Underscreen cleaning frequency: 10 bds per cleaning Note: We have decreased the cleaning frequency from 10 boards to 3 bds to reduce solder bridging after printing Regards,
Electronics Forum | Mon Apr 13 08:47:09 EDT 1998 | Bob Silveri
| | | | | | | We are having a bridging problem with SOIC 14,16 and 20 pin devices during flow solder of the bottom side of our boards. This bridging occurs about half way up the lead between the board and the body of the IC. The chip parts are no
Electronics Forum | Sat Aug 21 15:07:34 EDT 2010 | jry74
I have a problem with solder bridging between IC leads, especially fine pitch leads. If we lessen the apature ratio and/or decrease stencil thickness, I have more of a chance for unsoldered or insufficent joints. I am looking for any information th
Electronics Forum | Fri Aug 13 13:50:53 EDT 1999 | Brian Wycoff
| | | | | | Hello | | | | | | | | | | | | Having a problem with bridging on 20mil pitch qfp, only on the lead groups where squeegee goes over width of apertures. Using MPM sp-200 semi-auto, chem-etch stencil, 9-10mil width opening | | | | | | 100 du