Electronics Forum | Mon Aug 20 07:17:36 EDT 2012 | ericrr
Hi we have Juki KE-750L's is there any program to work out how many parts left on the reel, on the machine, the placement program does have a option to keep this number, but once you finish the run and start a new run the figure is lost. Unless I mis
Electronics Forum | Wed Jan 15 16:56:25 EST 2003 | Garth
Buy an electronic counter and simply spool your partial reels to an empty reel. It takes my staff a couple of hours to count every component on partial reels (~50 different values) and I have an exact number rather than an estimate.
Electronics Forum | Fri Mar 19 12:53:35 EDT 2010 | pcbrookie
Hello everyone. I'm looking for some general information on reel counters. We are trying to tighten our inventory counts, and rather than estimate a reel we're looking into getting an accurate count via a reel counter. So first, I'm wondering what
Electronics Forum | Tue Apr 03 00:37:51 EDT 2007 | grantp
Hi, I think the only solution would be to contact Fuji and ask if there is an interface to the machine to write software for it. I read somewhere that FujiTrax allows a IT system type connection which software could be written for. Another solution
Electronics Forum | Fri Jan 29 19:22:07 EST 1999 | Tony
| SMT Mfg. Equipment: Fuji CP-6/IP-3 - but please all hi-speed chip placer users input are appreciated !! | | The company that I work for is a C/M which offers both consignment but mostly turnkey work. I am currently running 3 Fuji lines. All parts
Electronics Forum | Mon Jun 30 03:21:38 EDT 2014 | sramos
Thanks Alexei for your advice. I consider mainly high-volume production with tape/reel feeders for most components and tray for big ICs. My ultimate goal is a cost estimation of the production activities. So departing from a parts-list, I need to est
Electronics Forum | Fri Oct 21 08:55:38 EDT 2005 | aj
All, I have been asked to review how we come up with costing of products. Basically, can anyone share how they do this i.e. If the machine can run 60 boards per hour what is a fair allowance for reel changes etc. I am guessing 15% . Any help/ad
Electronics Forum | Tue Mar 10 20:43:22 EDT 2020 | victorzubashev
Hi all, I am evaluating the value of the purchase of a universal automated programming machine for SMD IC components(no operator to load/unload the component ). input: SMD reel, JEDEC tray, tubes output: JEDEC tray Required throughput: between 10,000
Electronics Forum | Tue Mar 31 09:22:48 EDT 2015 | rgduval
I've always hated using machine specs....they're always best case scenarios, and nearly never capture actual through-put rates. Personally, I don't like using first-piece rates, either...unless you're looking for worst case scenarios. Usually, the
Electronics Forum | Sun Mar 09 18:33:04 EST 2003 | Dean
Tact time is a poor measure of your throughput capability. The Number of boards produced per hour or shift or 24 hour period is the true measure of what you are really doing. Your theoretial "tact time" can be used as a metric to judge performance,
