Electronics Forum | Tue Mar 12 16:01:32 EDT 2024 | SMTA-64387182
What is the best IPC standard to refer to for Cleaning of Printed Board Assemblies? Thanks, Joe
Electronics Forum | Wed Mar 27 16:32:22 EDT 2024 | SMTA-64387182
Thanks all, That is very helpful. Joe
Electronics Forum | Wed Mar 13 13:08:31 EDT 2024 | lambert
Section 8 in the J-STD-001 was the initial place to start with cleaning and the requirements, however with all the changes going on within the industry with increase product densities and such, a revision is being created to help understand the need
Electronics Forum | Thu Mar 14 15:55:34 EDT 2024 | davef
Process Requirement Standard - J-STD-001 - Requirements for soldered electrical and electronic assemblies depicting minimum end product acceptable characteristics as well as methods for evaluation (test methods), frequency of testing and applicable a
Electronics Forum | Tue Sep 15 19:21:38 EDT 2020 | edvardvojvoda
Because after we set the reference point at the right place, the program is working. The problem is.. the DEK try to find the reference point at different locations, it happens mostly at changeovers and sometimes before the fiducial check. When it l
Electronics Forum | Wed Dec 09 14:38:28 EST 2015 | jax
You can set the Horizontal and Vertical size of the reference designators. 1.Modify 1 to the size you want 2.Select all of the Reference ID's except the one you manipulated 3.Hold Ctrl down and select the Manipulated Reference 4.Click the "Set Horizo
Electronics Forum | Mon Jun 19 09:15:46 EDT 2006 | heatherc
The CircuitCAM product that Dave referred to below is sold by Aegis Industrial Software. They can supply you many references from the 250+ sites using the software to program the Mydata as well as sites utilizing the Orbotech equipment programming f
Electronics Forum | Wed Feb 10 07:50:52 EST 1999 | michele sommaruga
I am referring to reflowing twice. Fist time I reflow the up side, turn the PCB and reflow the bottom side. | By double reflow are you referring to double sided reflow? Or are you referring to reflowing twice? | | | | I would like to have informat
Electronics Forum | Mon Oct 13 01:28:37 EDT 2008 | kywl
Hi, I would like to ask if there's a guideline/specification on what is needed to qualify a new SMT automated assembly line? Is there any standards i can refer to? IPC or JEDEC? Is there a reference number for the standards so i can refer to as we
Electronics Forum | Thu Sep 24 04:49:45 EDT 2009 | d0min0
that crossed our minds - overloading of the oven but in reality we produce 5 references with very little output difference (close to 2 sec difference) so it should be a problem since a few yeats and on all references...? no only on 2 references from
.gif)
