Electronics Forum | Thu Dec 22 15:36:03 EST 2005 | CC
In general two step temperature reflow process requires minimum 40 deg C delta to be sucessful. We are not using vapor phase soldering but we have similar situation when we change to SAC lead free solder for PCB component population and secondary swe
Electronics Forum | Thu Jun 10 15:46:56 EDT 1999 | Chrys Shea
| Does anyone out there involved in RF manufacture have any experience with the KIC Slim-Kic profiler? Do you find any interference problems between the RF transmissions and the testing of your products. We build primarily high-freq stuff like point-
Electronics Forum | Thu Mar 05 11:53:09 EST 2009 | dcell_1t
Hello to all. for certain time, we have been struggling with some issues on a PCB where have tombstoning on 0402 components (due to pad design) and dewetting in qfp256 0.5 mil pitch (discussed on another threads on this forum) component, we have pro
Electronics Forum | Thu Jun 10 21:43:18 EDT 1999 | Dean
| | Does anyone out there involved in RF manufacture have any experience with the KIC Slim-Kic profiler? Do you find any interference problems between the RF transmissions and the testing of your products. We build primarily high-freq stuff like poin
Electronics Forum | Fri Feb 27 11:33:32 EST 2004 | Bryan
Very strange question,but interesting.Is there anyone who have conducted any experiments to figure out the results?I made a profile board,one thermal couple on pad and other one drilled into the ball of BGA.the 2 points are perpendicular to conveyor
Electronics Forum | Sat Jun 12 16:45:48 EDT 1999 | JohnW
| | | Does anyone out there involved in RF manufacture have any experience with the KIC Slim-Kic profiler? Do you find any interference problems between the RF transmissions and the testing of your products. We build primarily high-freq stuff like po
Electronics Forum | Sat Jun 12 17:41:13 EDT 1999 | JohnW
| | | Does anyone out there involved in RF manufacture have any experience with the KIC Slim-Kic profiler? Do you find any interference problems between the RF transmissions and the testing of your products. We build primarily high-freq stuff like po
Electronics Forum | Tue Jun 15 16:37:17 EDT 1999 | Philip Kazmierowicz
| | | | Does anyone out there involved in RF manufacture have any experience with the KIC Slim-Kic profiler? Do you find any interference problems between the RF transmissions and the testing of your products. We build primarily high-freq stuff like
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
| 1 |
