Electronics Forum | Mon Jun 10 13:37:03 EDT 2019 | slthomas
How wide is this board? I ask because if it's not terribly wide, you might just be better off attacking the problem with the profile rather than attacking the board conveyor design.
Electronics Forum | Tue Jan 14 10:48:07 EST 2020 | dontfeedphils
I've worked with these quite a bit in the past as well. As the previous poster mentioned, we ran either 4/5 mil thick stencil with a pretty standard RTS profile in a 10 zone convention oven without issue.
Electronics Forum | Thu Jul 27 21:34:41 EDT 2000 | Dave F
Gary: That's curious. Tell us more about your process steps, temperature profiles, paste, warping of the board without the PIH processing, components, etc
Electronics Forum | Wed Jan 15 07:25:37 EST 2003 | Jean-Philippe
LPMTF means Low Profile Multi-Tube Feeder and EMTF means Extended Multi-Tube Feeder. The difference is that the EMTF is bigger and it supports a wider range of tube.
Electronics Forum | Thu Feb 16 12:41:50 EST 2006 | fredericksr
Hey folks, I was interested in any information that you might have on tombstone reduction when using a lead free solder and profile. Thanks for any input that you may have! -Russ #x
Electronics Forum | Sun Dec 17 18:14:12 EST 2006 | greg york
circuitmaster designs prowave is unbeatable. They may have an agent in the usa if interested I will try to find out for you. cheers greg
Electronics Forum | Tue Dec 19 10:08:10 EST 2006 | George
Grant, Why don't you try a water-base flux which is No-clean, VOC-free also? I have tried the 270WR flux from AIM with good results even on lead-free process. My $0.02, George
Electronics Forum | Tue Dec 19 12:01:29 EST 2006 | patrickbruneel
Here�s a link to a previous thread that might be helpful http://www.smtnet.com/Forums/index.cfm?fuseaction=view_thread&CFApp=1&Thread_ID=6947&#Top Look what KEN has to say on the subject Patrick
Electronics Forum | Thu May 29 13:12:10 EDT 2008 | yam6rider
Just like to know what you guys thoughts regarding mixed alloys. Production run SAC305 and some components are SAC105. So, which profile should you follow. SAC105? or SAC305.
Electronics Forum | Wed Jul 02 08:30:32 EDT 2008 | interflux_electronics
Why not follow SAC305? you would do so for any other component finish wouldn't you? A component finish of pure Sn would also not call for a pure Sn profile, would it?
