Electronics Forum | Mon Jul 01 09:33:08 EDT 2019 | dbuschel
if you can't change the PCB materials or design at this point, you might be able to reduce it somewhat through the use of fixtures or edge stiffeners. Unless it is a particularly thick board, I don't think the reflow profile would be the issue. The t
Electronics Forum | Fri Sep 17 06:01:12 EDT 1999 | Earl Moon
| | We have some SMT components with gold plated leads. They're actually LCC led packages. A good solder alloy to use would be Indium / Lead to reduce tin dissolution into the gold and avoid the resultant brittle intermetallic compound. However, a re
Electronics Forum | Fri Sep 17 09:54:40 EDT 1999 | Brian
| | | We have some SMT components with gold plated leads. They're actually LCC led packages. A good solder alloy to use would be Indium / Lead to reduce tin dissolution into the gold and avoid the resultant brittle intermetallic compound. However, a
Electronics Forum | Fri Sep 17 10:09:17 EDT 1999 | Earl Moon
| | | | We have some SMT components with gold plated leads. They're actually LCC led packages. A good solder alloy to use would be Indium / Lead to reduce tin dissolution into the gold and avoid the resultant brittle intermetallic compound. However,
Electronics Forum | Thu May 26 16:41:00 EDT 2011 | scottp
Here's what I do: - Test Surface Insulation Resistance (we're in the high reliability market and use a test significantly harder than IPC's). I also test SIR in combination with other assembly materials like conformal coatings and wave solder flux
Electronics Forum | Thu Nov 02 03:42:49 EST 2000 | CHRIS MAY
Tombstoning primarily occurs due to the fact that the paste may melt and wet the metallized face of the chip earlier or better at one end than the other. This could be due to a difference in heat capacity (thermal shadowing ?) or that one end of your
Electronics Forum | Tue Sep 24 22:29:04 EDT 2002 | davef
First, I don't have a clear fix on the problem. Please drill-down to more detail. We appreciate that you probably don't know the parlance. Just describe what you have and then what you'd like to have. Second, most 0402 LED are fabricated just lik
Electronics Forum | Thu Apr 24 23:04:45 EDT 2003 | yukim
I've been struggling with this problem for a while. We have two products: A, which is Ok and B, with tombstone defect (0603 & 0805 capacitor chips). A & B have the same design: pad sizes, separation between pads, components orientation. Both have s
Electronics Forum | Mon May 05 03:53:41 EDT 2003 | praveen
Do not 'ON" the nitrogen during reflow. If the pad of the chip is bigger then reduce the pad width from out side. Reduce the ramp rate at any point of the profile below 1 deg c/sec.
Electronics Forum | Mon May 05 03:53:47 EDT 2003 | praveen
Do not 'ON" the nitrogen during reflow. If the pad of the chip is bigger then reduce the pad width from out side. Reduce the ramp rate at any point of the profile below 1 deg c/sec.