Electronics Forum | Mon Mar 11 07:05:06 EDT 2024 | klauss
while conveyor goes down to relaese pcb, some big compoments are swinging left or right due to high down speed of the conveyor. is there any way to decrease the speed?
Electronics Forum | Mon Jan 15 13:49:09 EST 2007 | leemeyer
Hello all, I am having some trouble with the conveyor speed on an Omniflow 7 reflow oven. Recent profiling showed that the conveyor was running to slow so I calibrated the speed using the instructions in the manual. After calibration there was no ch
Electronics Forum | Mon Nov 01 09:56:57 EDT 2021 | richardcargill
Update - Solved On talking with BTU they mentioned that if the conveyor is always running full speed then cleaning out the motor brush area with compressed air will cure it. I'm guessing that the carbon dust had encroached onto the encoder. A good b
Electronics Forum | Fri Oct 29 07:19:22 EDT 2021 | richardcargill
Thanks for the file, it explains pretty much everything we needed. It would seem we have more problems than just that now, I've got the conveyor physically running at about 18 i/m but the Actual speed display on the screen reckons it's several hund
Electronics Forum | Fri Jul 19 14:20:19 EDT 2013 | dontfeedphils
I'm at a different, smaller company now. I'm using YesTech now as well, but only as post reflow inspection later in the process, no pre-reflow.
Electronics Forum | Wed Sep 22 19:10:39 EDT 2004 | Rush Fan
I was wondering if anyone has ever considered measuring the belt speed of their reflow ovens using some type of hand-held, preferably non-contact device? If so, could you recommend a manufacturer of such a device? We are considering measuring our act
Electronics Forum | Fri Jul 19 10:01:30 EDT 2013 | dontfeedphils
In a past life I ran F1 systems post placement / pre reflow behind a MyData My12E, so it didn't exactly have to keep up with a speedy chip shooter, but it did pretty well. The AOI would end up being the bottle neck some of the time, but not because
Electronics Forum | Tue Nov 07 06:36:39 EST 2023 | ravikumargv
Dear All. Good day.. We have one Omniexcel dual conveyor reflow and recently we had PC got gone bad and now we replaced new mother board and hard disk, but we don't have the previous PC backup, now we need the software. kindly help us to share the
Electronics Forum | Fri Nov 17 03:41:38 EST 2023 | ravikumargv
Dear All, Any update for the below request. Please do the needful as soon as possible
Electronics Forum | Wed Jan 17 21:19:08 EST 2007 | Jnet
I believe the drive of the conveyor whether rail or belt is the same so the sprocket choice in the software would effect belt or rail conveyor speed. I would make sure the number of teeth match the sprocket selection in the software.
