Electronics Forum | Mon Jan 15 13:49:09 EST 2007 | leemeyer
Hello all, I am having some trouble with the conveyor speed on an Omniflow 7 reflow oven. Recent profiling showed that the conveyor was running to slow so I calibrated the speed using the instructions in the manual. After calibration there was no ch
Electronics Forum | Tue Jun 17 07:17:09 EDT 2003 | James
The main problem I am having is getting the Rising slope 1-3 degrees. If I slow the conveyor down then I have too long of a reflow and if I speed it up then my ramp rate is too high. I was not sure if I need my first zones at a low temp or higher t
Electronics Forum | Thu Jun 26 04:34:49 EDT 2003 | emeto
Hi James, I saw very good posts here.Now I will give you one more practical way: 1. My advice is to encrease the temperature(like your first sidgestion). Termostress is important thing so your first zone should be 120-150C. 2. The paste profile. If
Electronics Forum | Tue Jun 24 06:58:53 EDT 2003 | sanjeevc
Hi The temprature for the first zone should be more as the PCB entering the oven from the ambient shop floor temprature needs a higher temp.Next zone could be lower than the first zone.The ramp is a relation of conveyor speed and the temp profile.T
Electronics Forum | Wed Jun 25 18:17:48 EDT 2003 | Brian W.
Water soluble pastes generally work best with a ramp-to-spike reflow profile. Check your paste manufacturer's recommended profile. There are many factors that impact your profile; board thickness, component density, buried thermal masses, board si
Electronics Forum | Mon Feb 07 12:47:18 EST 2005 | Indy
1. use 6-7mils stencil. 2. reduce aperture opening to 60-70% of pad size. 3. check viscosity of solder paste. According to that you might want to alter your print speed and pressure. Cheers Indy
Electronics Forum | Thu Jan 08 11:06:40 EST 2004 | russ
If I read this correctly you have two identical ovens that were setup the same ie zone temps, fan speeds etc... when you ran the same board through each of them one showed a lower board temp. Is this correct? Is the temp of the board 7 deg. lower t
Electronics Forum | Thu Sep 16 12:06:29 EDT 1999 | Scott S. Snider
| | | Hi, | | | | | | Can someone pls suggest to me the best reflow temperature setting | | | for a force air convection oven. The details is as follow. | | | 1) Heller 1700s | | | 2) 12 zone---6 top and 6 bot | | | 3) Solder paste --- Qualitek 691
Electronics Forum | Thu Sep 27 21:19:56 EDT 2001 | stimpy
>> try a linear ramp to allow the entire pcb to heat up evenly. What is your conveyor speed?
Electronics Forum | Tue Jun 28 13:23:56 EDT 2005 | Bob Gilbert
Matt, Try a cooler profile by simply speeding up the conveyor by 10%. The difference may be the temperature the pads are reaching between the HASL boards and the Au boards. Are they the same thickness?
.gif)
winsouce.jpg)