Electronics Forum | Fri Feb 10 09:18:04 EST 2006 | aj
is that fan speed program controlled or manually?
Electronics Forum | Thu Feb 09 09:36:55 EST 2006 | aj
All, I would like to find out if it is possible to adjust the cooling rate on a Conceptronic Reflow Oven Model HVN70. We do not use Nitrogen and the Cooloing system is Genesis GCM-1. From profiling it seems to be cooling too quickly. Any replies a
Electronics Forum | Thu Feb 09 09:45:50 EST 2006 | PWH
I'm not familiar with the HVN70 programming but our conceptronic oven reacts well to adjusting the cooling fan speed at the end of the oven. However, TAL will likely be affected substantially by changing fan speed.
Electronics Forum | Fri Feb 03 15:40:39 EST 2006 | chrisgriffin
Hello, I am looking for replacement cooling fans for the BTU oven cooling zone. The oven is a P98 model. BTU is back ordered, and I can't wait. Does anyone have any extras to sell, or know of an alternate source? Any help is greatly appreciated.
Electronics Forum | Mon May 10 10:08:16 EDT 1999 | Rich Taylor
Can anyone tell me what the recommended "typical" cooling rates are after reflow? Are the cooling rates considered as critical to control as the heating rates and why/why not?
Electronics Forum | Mon May 10 13:55:22 EDT 1999 | Deon Nungaray
| Can anyone tell me what the recommended "typical" cooling rates are after reflow? Are the cooling rates considered as critical to control as the heating rates and why/why not? | I do not think there is a "typical" post reflow cooling rate out ther
Electronics Forum | Wed Jan 11 15:21:51 EST 2012 | pr
Can anyone recommend fans to put on the conveyors post reflow? Thank you, PR
Electronics Forum | Wed May 12 10:29:25 EDT 1999 | Timothy O'Neill
| | | Can anyone tell me what the recommended "typical" cooling rates are after reflow? Are the cooling rates considered as critical to control as the heating rates and why/why not? | | | I do not think there is a "typical" post reflow cooling rate
Electronics Forum | Mon May 10 15:49:52 EDT 1999 | Steve Gregory
| | Can anyone tell me what the recommended "typical" cooling rates are after reflow? Are the cooling rates considered as critical to control as the heating rates and why/why not? | | I do not think there is a "typical" post reflow cooling rate out
Electronics Forum | Thu Dec 21 09:32:35 EST 2006 | Brandon
Does anyone know of a source other than speedline? I know these can be had for $100. Speedline wants $1600. It is a cooling zone blower motor for a cross blow system. Not the same blower you see on the top of the heating zones. This one mounts from t
