Electronics Forum | Mon Feb 04 10:17:39 EST 2008 | slthomas
Your oven no doubt compensated by reducing energy to your heaters so it might not be as bad as you think. I'd be more concerned about even heating than over heating. My opinion is that an out of calibration profiler result is better than no result
Electronics Forum | Wed Sep 12 11:03:35 EDT 2007 | cyber_wolf
Ya I am hip on the caps. These blowers squeel then quit.
Electronics Forum | Wed Sep 12 11:01:49 EDT 2007 | leemeyer
We have an Omni 7. We were having problems where blowers wouldn't start. Turned out to be the start capacitors and not the blowers. I replaced all of the caps and haven't had any issues since.
Electronics Forum | Tue Sep 11 08:36:53 EDT 2007 | cyber_wolf
We seem to have a lot of blowers going bad on our Omni 10 lately. We run PB free and/or elevated sn/pb profiles on a regular basis. I am starting to suspect that the elevated zone temps are causing the blowers to fail. Has anyone else had this prob
Electronics Forum | Wed Sep 12 13:11:50 EDT 2007 | nitro
Usually the bearings lock up. I keep one spare blower on hand and change it out when I have one go bad, then take the bad one apart and change the bearings. The bearings are about $4.00 per set and are pretty common. Not too hard to find. I am using
Electronics Forum | Fri May 20 09:45:57 EDT 2005 | young
Hello, I was wondering if anyone knows where I could get a solder pot exhaust fan? Here are the specifications: Manufacturer: Emerson Description: Belted Fan + Blower Duty Model: S63CXJDJ-7165 CAT: 5795C HP: 3/4 RPM: 1725/1140 Voltage: 115 Hz: 60
Electronics Forum | Mon Jul 10 14:08:23 EDT 2023 | proceng1
But isn't this referring to "inside the facility"? I think he's asking about polluting the outside air.
Electronics Forum | Thu Feb 07 14:29:02 EST 2008 | jdumont
Bi monthly?!!? What are your exhausts getting clogged with? You have that much dust in the air that cleaning every two weeks is necessary?
Electronics Forum | Tue Feb 12 14:18:48 EST 2008 | pjc
Without forced exhaust your oven will struggle to regulate zone temps, especially if a cooler one next to a hotter one. There should be no damage to the oven, just working harder to regulate itself.
Electronics Forum | Mon Feb 11 17:30:59 EST 2008 | blnorman
The solder problems that were created caused overcompensation. Plus our PM schedules could be monthly, could be yearly depending on the maintenance crew for a particular line.
