Electronics Forum | Mon May 13 03:01:23 EDT 2019 | peterchan
Hello, sir. We are a SMT equipment manufacturer from China. We have a hot-press soldering machine that can change your current situation of manual soldering on PCB board. In addition, we have a better reflow oven, the upper and lower two cold tempe
Electronics Forum | Tue Jul 28 17:23:58 EDT 1998 | Robert Steltman
| | We are about to run our first BGA devices and would appreciate some confirmation on a few points. | | First some details: | | PCB & Device: | | ============= | | 1) 16 layer (4 power, 4 gnd, 8 signal) | | 2) gold on nickel finish | | 3) ceramic
Electronics Forum | Wed Feb 21 15:29:34 EST 2007 | wavemasterlarry
I here alot of guys at my place talking about cold spots in the oven. You may want to check for them in yours.
Electronics Forum | Tue Jan 13 13:17:00 EST 1998 | Matt Brown
| We use no clean paste and sometimes experience | flux splattering which gives spot on gold fingers. | Need help in analize the cause. thx. Most often, the 'splattering' is caused by an excessive temperature in the oven: this can cause the solder p
Electronics Forum | Thu Apr 15 20:41:22 EDT 2004 | Ken
There are ledgitimate reasons for checking furnace calibrations, but let me clarify what that is. 1. TC's are not necessarily calibrted. Not unless you need "absolute" accuracy. TC's operate against a (non-linear) standard +/- a tolerance. Most
Electronics Forum | Mon Jan 19 20:01:11 EST 1998 | Steve Gregory
| We use no clean paste and sometimes experience | flux splattering which gives spot on gold fingers. | Need help in analize the cause. thx. Dominic, That is STILL a problem huh? It's a tough one to solve sometimes...especially when you have as
Electronics Forum | Tue Oct 01 14:53:24 EDT 2013 | felo188
it's means that a pcb part responsible for second top zone is broken. To make sure i changed second thermocouple and heater with first. Now there is no overshoot. But I have still problem with automatically shutdown. It is turning off after 1 or 2
Electronics Forum | Wed Jun 25 12:08:53 EDT 2003 | russ
I battle this all the time, I don't believe that it is the "gold corner" that is causing the problem but something with the PCB layer makeup (copper planes, or bottom side components, etc.). It could also be the nozzle you are using has a "hot spot/
Electronics Forum | Mon May 01 23:23:58 EDT 2006 | grantp
Hi, I off center idea we used when we started. Get a pasta cooker, and put in vapor phase fluid, and then use that. Place the product in the bottom of the inner pot, and then heat on a small hot plate. When the vapor cloud gets high enough and the
Electronics Forum | Wed May 26 18:04:16 EDT 1999 | John Thorup
| After reflow proces in convection-IR oven we find broken body of SOT23 elements. There is no problems on other elements (SOIC, chip R,chip C, etc) | Where is the problem? | | Thanks in advance! | Check your profile at the site of cracked component
winsouce.jpg)